NRF51822 Bluetooth 4.0 Evaluation Kit - Waveshare 9549

The module is compatible with the Grove Base Shield and designed to implement a wireless serial connection. It uses Bluetooth 4.0 (BLE) HM-11 and UART communication. Seeed Studio 113020008

Bluetooth module with built-in CC2541 chip. The module is small, energy-saving and easy to use

Low Energy Bluetooth adapter module with USB 2.0 connector. allows communication with BLE devices

Bluetooth 4.0 BLE module powered with 3.3V voltage based on SOC TI CC2541 (On Chip). The module has a range of up to 10m and communicates via the UART interface.

An advanced wireless communication module based on the Bluetooth 5.2 (Bluetooth® Low Energy, BLE) stack, which is designed using the powerful Nordic nRF5340 SoC. It provides GPIO, SPI, UART, TWI, I2C, PDM, PWM, ADC, NFC and USB interfaces for connecting peripherals and sensors. SparkFun WRL-25465

Evaluation kit with Bluetooth 5.0 Sparkfun Artemis module. Equipped with a microphone, kmaers and accelerometer. SparkFun DEV-16828

The module with the HC-05 compatible transceiver makes it easy to add Bluetooth communication to an existing project. The system is controlled by exchanging AT commands (UART bus)

Board with the Artemis chip, the GNSS ZOE-M8Q module and the Iridium 9603N satellite receiver. It allows you to send and receive short messages with data anywhere in the world. SparkFun WRL-18712

The BLE Nano from RedBearLab is the smallest Bluetooth 4.1 Low Energy (BLE) development board on the market. With the included MK20 USB in this kit, you’ll be able to deploy firmware to BLE Nano even easier. WRL-14071/WRL-13730

Expansion board with BlueNRG-M0 module compatible with Bluetooth v4.2. It is compatible with the ST morpho connector system (unmounted) and Arduino UNO R3. Communication with the module is via the SPI interface. STMicroelectronics X-NUCLEO-IDB05A2

A development board that combines the u-blox NINA-B306 Bluetooth module, the ISM330DHCX 6DoF IMU sensor, and the BME280 atmospheric pressure sensor. It has a built-in Qwiic connector and LiPo battery connector as well as a charger and LiPo parameters monitor. SparkFun WRL-20854

The BLE 4.0 Bluetooth module with the CC2541 system has an integrated PCB antenna and an extensive AES security system. Thanks to the built-in system CC2541 from Texas Instruments, it is possible to create a project without the use of an additional microcontroller. modCC2541

WiFi/BLE module that supports both the 2.4 GHz and 5 GHz WiFi bands, as well as Bluetooth Low Energy (BLE 4.2) communication. It has a u.FL connector dedicated to connecting an external antenna and a connector with a 2.54 mm pitch, which greatly facilitates prototyping. Tibbo WA2000U

Bluetooth 5.0 module based on the BT401 chip. It allows you to send audio and support microSD cards up to 128 GB. DFRobot DFR0781

WRL-13019