.png)
ACHS-7123 Current Sensor Carrier - ACHS-7123 ±30A current sensor module
ID: 586603
5902186326651
zł17.18
Tax included
zł13.97 tax excl.
Module with ACHS-7123 current sensor with a measuring range of direct and alternating current from -30 to 30 A. It communicates via an analog interface. Pololu 4032
Description
Module with a bidirectional Hall current sensor based on the ACHS-7123 system. It allows you to measure the current in the range from -30 to 30 A. The board is powered with the voltage from 4.5 V to 5.5 V and is intended for use in circuits with a logical voltage of 5 V. It offers a current path with low resistance (~ 0,7 mΩ) and electrical insulation up to 3 kV RMS. The output is a proportional analog voltage (66 mV/A) centered at 2.5 V with an error of ± 1.5%.
The sensor requires five connections to work properly: input current (IP+ and IP-), logic power (VCC and GND) and sensor output (OUT). Pin FILTER allows you to adjust the bandwidth of the plate by adding a capacitor to ground in parallel with the 1 nF capacitor that is already on the board. Without an additional external filter capacitor, the frequency response is approximately 80 kHz.
Features
- Hall effect differential detection
- The internal resistance of the conductive path is 0.7 mΩ
- Electrical insulation up to 3 kV RMS
- High bandwidth up to 80kHz for fast response times
- Integrated digital temperature compensation circuit
- The rugged sensor IC can tolerate 100 ms to 100 A transient currents
- Operating voltage 4.5 to 5.5 V
- Current measuring range from -30 to 30 A
- Output resolution 0.066 V/A
- Operating temperature range from -40°C to 110°C
- Dimensions: 17.8 x 20.3 mm
- Weight: 1.1 g
Kit contains
- ACHS-7123 Current Sensor Carrier module
- Straight 3-pin male connector
586603
Data sheet
- Interface
- Sygnał analogowy
- Zakres pomiarowy
- ±30 A
- Sposób podłączenia
- Szeregowy
Manufacturer
- BTC Korporacja sp. z o. o.
- Ludwinowo Zegrzyńskie 52G
- 05-140 Ludwinowo Zegrzyńskie
- Poland
- [email protected]
- 22 767 36 20
Responsible person
- BTC Korporacja sp. z o. o.
- Ludwinowo Zegrzyńskie 52G
- 05-140 Ludwinowo Zegrzyńskie
- Poland
- [email protected]
- 22 767 36 20
You might also like
Module with an analog AC current sensor in a set with a probe for non-contact measurement of alternating current with a current of up to 20 A. DFRobot SEN0211
zł91.49
24h
Available quantity: 1
Available
Module with ACS724LLCTR-30AU current sensor with a measuring range of direct and alternating current from 0 to 30 A. It communicates via an analog interface. Pololu 4046
zł38.92
24h
Available quantity: 1
Available
Module with an analog AC current sensor in a set with a probe for non-contact measurement of alternating current with a current of up to 5A. DFRobot SEN0287
zł82.20
24h
Available quantity: 3
Available
A set of 40 pieces of female-female connecting cables in various colors, 10 cm long
zł4.90
24h
Available quantity: 208
Available
A set of 40 pcs of male-female connecting cables in various colors, 10 cm long
zł4.48
24h
Available quantity: 396
Available
A set of 40 pcs of male-male connecting cables in various colors, 10 cm long
zł5.10
24h
Available quantity: 488
Available
Other products in the same category (16)
Pololu 5326 current sensor provides electrically isolated DC current measurement in the range of 0 A to 50 A. Based on the Allegro CT432-HSWF50DR sensor, the module utilizes TMR technology, offering a 1 MHz bandwidth and an analog interface. Pololu 5326
zł63.92
24h
Available quantity: 5
Available
Pololu 5242 with the ACS71240KEXBLT-050B3 chip is a compact current sensor module for precision measurement applications in the ±50 A range. With galvanic isolation, fast response to current changes, and short-circuit detection capability, it is used in power systems, automotive and industrial electronics, and embedded projects. It is ideal for measuring currents in both DC and AC circuits while ensuring safety and accuracy.
zł19.98
4 weeks
No product available!
Pololu 5328 current sensor provides electrically isolated DC current measurement in the range of 0 A to 70 A. Based on the Allegro CT432-HSWF70DR sensor, the module utilizes TMR technology, offering a 1 MHz bandwidth and an analog interface. Pololu 5328
zł63.92
24h
Available quantity: 5
Available
Pololu 5333 current sensor provides electrically isolated AC and DC current measurement in the range of -50 A to +50 A. Based on the Allegro CT433-HSWF50MR sensor, the module utilizes TMR technology, offering a 1 MHz bandwidth and an analog output signal.
zł63.92
24h
Available quantity: 3
Available
Pololu 5335 current sensor provides electrically isolated AC and DC current measurement in the range of -70 A to +70 A. Based on the Allegro CT433-HSWF70MR sensor, the module utilizes TMR technology, offering a 1 MHz bandwidth and an analog voltage output.
zł63.92
24h
Available quantity: 5
Available
The module enables unidirectional AC and DC current measurement over a range from 0 A to 50 A. XtremeSense™ TMR technology, an electrically isolated current path, 1 MHz bandwidth, and an analogue voltage output support use in systems requiring fast current measurement and high dV/dt immunity. Pololu CT433-HSWF50DR Large Carrier 0–50 A, 3.3 V
zł63.92
24h
Available quantity: 2
Available
The module enables unidirectional AC and DC current measurement over a range from 0 A to 65 A. XtremeSense™ TMR technology, an electrically isolated current path, 1 MHz bandwidth, and an analogue voltage output support use in systems requiring fast current measurement and high dV/dt immunity. Pololu CT433-HSWF65DR Large Carrier 0–65 A, 3.3 V
zł63.92
24h
Available quantity: 2
Available
The INA3221 module, which allows simultaneous measurement of voltage and current for three power supplies via I2C with ±1% precision. With a 13-bit ADC and built-in 0.05Ω shunt resistors, it allows accurate monitoring of currents up to ±3.2A and voltages up to +26VDC. Adafruit 6062
zł56.38
24h
Available quantity: 2
Available
HSTS08L 10A 2.5V Current Sensor. Enables measurement of high currents. modHSTS08L
zł66.10
24h
Available quantity: 3
Available
SCT010T-D 10A 5V AC Current Sensor. Enables measurement of high AC currents. modSCT010T-D
zł29.78
24h
Available quantity: 4
Available
Compact current sensor based on TMR technology, enabling precise measurements up to 30 A with minimal energy losses. Thanks to a wide 1 MHz bandwidth, galvanic isolation and interference immunity, it is perfect for applications requiring fast response and high accuracy. Pololu 5317
zł52.07
24h
Available quantity: 3
Available
Compact current sensor based on TMR technology, enabling precise measurements up to 20 A with minimal energy losses. Thanks to a wide 1 MHz bandwidth, galvanic isolation and interference immunity, it is perfect for applications requiring fast response and high accuracy. Pololu 5316
zł52.05
24h
Available quantity: 2
Available
Compact current sensor based on TMR technology, enabling precise measurements up to 30 A with minimal energy losses. Thanks to a wide 1 MHz bandwidth, galvanic isolation and interference immunity, it is perfect for applications requiring fast response and high accuracy. Pololu 5305
zł50.58
24h
Available quantity: 2
Available
Compact current sensor based on TMR technology, enabling precise measurements up to 20 A with minimal energy loss. Thanks to a wide 1 MHz bandwidth, galvanic isolation and interference immunity, it is perfect for applications requiring fast response and high accuracy. Pololu 5304
zł55.63
24h
Available quantity: 5
Available
Precision Hall effect current sensor, providing galvanic isolation and wide 250 kHz bandwidth. Low conductive path resistance, magnetic interference immunity and ratiometric analog output make it ideal for AC and DC current monitoring applications. Pololu 5281
zł68.49
24h
Available quantity: 3
Available
The ACS72981 current sensor module uses the Hall effect to accurately and safely measure AC and DC current, providing electrical isolation of the current path. With a wideband analog output (up to 250 kHz) and low conduction resistance (0.2 mΩ), it minimizes energy loss and offers a fast response time of less than 2 µs. Pololu 5261
zł56.38
24h
Available quantity: 2
Available
Module with ACHS-7123 current sensor with a measuring range of direct and alternating current from -30 to 30 A. It communicates via an analog interface. Pololu 4032