Waveshare USB converter module - FIFO with FT245 mini USB

UART-CAN converter module based on the TJA1050 transceiver system. It allows for communication, for example, of a microcontroller via the CAN bus

The Step-Down converter module on the MP1584EN chip converts the 4.5-28V input voltage to 12V output voltage with a maximum current of 3A and an efficiency of up to 92%. It is a compact device measuring 22 x 17 x 4 mm, operating in a temperature range of -20°C to 85°C, ideal for a variety of industrial applications.

Module with a slide potentiometer. Depending on the position of the slider, the resistance value (maximum resistance 10kΩ) changes, which translates into the voltage value at the analog output of the module. The module has a connector in accordance with the Grove standard. Seeed studio 101020036

C-mount lens. Focal length 50mm, FoV 10°(H), 7°(V). Designed to work with the Raspberry Pi HQ camera. ArduCAM LN054

The MQ-9 sensor allows the measurement of gas concentrations such as carbon monoxide, propane and methane. Sensor measuring range: 10 - 10,000 ppm

The kit includes a control module (with ETA1617 and NE555) and an ultrasonic transducer. The water atomiser module allows for the construction of, for example, a small humidifier. The module has a connector in accordance with the Grove standard. Seeed studio 101020090

Module with one 5 V relay with a maximum switching current of 10 A. It communicates via a USB interface and does not require additional power supply. Numato Lab NLRL1001-A

A single-channel DC motor controller with a UART TTL interface. It is powered from 1.8 V to 22 V and can deliver up to 1.8 A of current. Board with soldered connectors. Pololu 5076

This is a breakout board for ON Semiconductor’s AMIS-30543 microstepping bipolar stepper motor driver, which features SPI-adjustable current limiting, 11 step modes (from full-step through 1/128-step), back-EMF feedback that can be used for stall detection or optional closed-loop control, and over-current and over-temperature protection. 

DFRobot DFR0316

RS232/RS485 to WiFi and Ethernet converter that provides easy communication between RS232 or RS485 interface and WiFi wireless network and wired LAN network. Supports the Modbus RTU protocol. USR-W630

Gravity module designed based on the GP8512 system. It is a single-channel DAC (analog-to-digital) converter with I2C communication that offers an output signal with a resolution of 15-bit and an accuracy of 0.01%. It allows you to generate analog signals with a voltage range from 0 to 2.5 V or from 0 to VCC. DFRobot DFR1035

Analog audio level indicator in the form of a panel meter. Powered with AC or DC voltage from 6 to 12 V, it has a built-in backlight

The analog pH meter, specially designed for Arduino controllers, with the connector (Gravity series). It has an LED which works as the Power Indicator, a BNC connector and PH2.0 sensor interface. The pH measurements at ± 0.1pH (25?). SEN0161

The oCam supports plug-and-play by UVC compliant adapting the standard M12 lens with focal length of 6mm

Step-Down converter with adjustable output voltage from 4.2 V to 15 V and output voltage up to 45 V. It is equipped with reverse voltage protection, input undervoltage lockout, overload and short circuit protection. Pololu 4854