

zł19.77 tax excl.
Module with a 1.44 "color liquid crystal display and 128 x 128 pixel resolution The display has a built-in ILI9163C driver. Thanks to the pin connector, the module can be easily attached to the contact plate or wires 1.44 'SPI 128 * 128 V2.1
Module with 1.44 "color liquid crystal display and 128x128 pixel resolution The display has a built-in ILI9163C driver. Thanks to the pin connector, the module can be easily attached to the contact plate or wires.
Attention!
The voltage on the display control lines should not exceed 3.3 V. To use the display with 5 V bus signals, we recommend using a logic translator, eg KAmodLVC
Data sheet
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Set of 40 pieces of male-female connection cables, in various colors, 17 cm long. CAB_M-F (Rainbow-40-17)
No product available!
A set of 10 female-female connection cables, in various colors, 17 cm long. CAB_F-F (Rainbow-10-17)
TFT 1.8 "display module with SD, ST7735S, RoHS socket
Digitally controlled module with LED. Perfect for people starting their fun with Arduino. Equipped with an XH2.54 connector
No product available!
THT resistor, 0.25W, 5%, RoHS
ARK terminal connector spring 8-pin, pitch 3.81 mm, non-detachable
Unshielded UTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCU6-10CC-1000-Y
2-position waterproof self-locking rotary switch, 19 mm in diameter, in a stainless steel housing. Green colour
Advanced IEEE 802.11b/g/n WiFi controller in the 2.4GHz band, providing versatility and easy integration with systems thanks to SPI, UART, SDIO and USB interfaces. The WiFi software in the module is pre-loaded, allowing easy updates, which increases flexibility and adaptation to various applications. Segger emPower WiFi Module - Redpine Signals RS9113 (2.4 GHz) (6.37.03.02)
No product available!
Shielded FTP category 5E Ethernet network cable with RJ45 plugs. Lanberg PCF5-10CC-0200-S
AS7331 UV light sensor module. It allows you to measure UV radiation on three channels: UVA (320-400nm), UVB (280-320nm) and UVC (200-280nm). Communication with AS7331 takes place via the I2C interface and the Qwiic connector. SparkFun SEN-23518
Test kit with 8 pogo pin probes designed to work with boards with ICSP or FTDI interface. It allows you to program the set without the need to solder the pins. A kit for self-assembly. DFRobot DFR0359
A miniature camera module with a 5MP OV5647 sensor dedicated to the Raspberry Pi. Designed for spy systems where image size and quality are important. Without IR filter. ArduCAM B0066-02
No product available!
5 mW red laser diode module, displaying a point. Ideally suited as an indicator element, and thanks to the built-in driver it is possible to supply voltage from 2.8 V to 5.2 V. Adafruit 1054
Ultrasonic obstacle sensor (vehicles) with high resolution and range up to 500cm with USB interface. It allows you to perform measurements at 4Hz. DFRobot SEN0268
No product available!
A single high-throughput operational amplifier in the SOT23-6, 10 MHz, 17.7 V / μs housing, 4V to 16V. STMicroelectronics TSX920ILT
The audio adapter with a 15-cm cable allows you to connect headphones with two 3.5 mm plugs to devices with one jack socket. This makes it possible to use traditional headsets with modern devices. Akyga AK-AV-08
Module with a 1.44 "color liquid crystal display and 128 x 128 pixel resolution The display has a built-in ILI9163C driver. Thanks to the pin connector, the module can be easily attached to the contact plate or wires 1.44 'SPI 128 * 128 V2.1