Products
Categories
- Main categories
-
- 3D PRINTING
- ACADEMIC OFFER
- ARDUINO
- AUTOMATION
- BOOKS
- DIY KITS
- AVT kits
- Audio
- Car
- Chargers
- Clocks, timers and schedule switches
- Communication
- Converters
- Development kits and modules
- Displays
- Electronic games
- Generators
- Hobbies and fun
- House
- Interfaces
- Light effects
- meters
- PC
- Power Supplies
- Pre-programmed circuits
- Printed circuit boards (PCB)
- Programmers
- Regulators, controllers
- Remote control
- Starter sets Ośla Łączka
- Starting sets for beginners
- Workshop tools
- Audio
- Other sets
- TOP-Q kits
- Totem
- UGears
- Velleman
- AVT kits
- EBOOKS
- ELECTRONICS
- Cables
- Cameras and accessories
- Communication
- Conductive materials
- Connectors
- ARK connectors (Terminal Block)
- Coaxial connectors (RF)
- Connectors
- Crocodile clip
- D-Sub drawer connectors
- DC power connectors
- FFC/FPC ZIF connectors
- Goldpin connectors
- IDC connectors
- JACK connectors
- JST connectors
- Jumpers
- Memory cards slots
- Other connectors
- Pogo pin
- RJ45 sockets
- Slip ring connector
- Supports
- Szybkozłącza
- USB connectors
- Cooling
- Displays
- Electronic modules
- A/D and D/A converters
- Audio
- Barcode readers
- CAN converters
- Converters USB - UART / RS232
- Data logger
- DDS/PLL generators
- Digital potentiometers
- Encoders
- Expanders of the I/O
- Fingerprint readers
- HMI modules
- Image and video
- JTAG accessories
- Keyboards, buttons
- LED drivers
- Memory card readers
- Memory modules
- Modules with power outputs
- Motor controllers
- Power modules
- RS485 converters
- RTC modules
- Servo Controllers
- TSOP infrared receivers
- USB Converters - I2C / 1-Wire / SPI
- Voltage converters
- Gadgets
- GPS
- Intelligent clothes
- LED - diodes, displays, stripes
- Luminous wires and accessories
- Memory cards and other data storages
- Passive elements
- PC accessories
- Printers
- Prototype boards
- Semiconductors
- A/C converters (ADC)
- Analog systems
- Audio systems
- Bridge rectifiers
- Button
- D/A Converters (DAC)
- DDS synthesizers
- Digital circuits
- Diodes
- Drivers of motors
- DSP microprocessors
- Energy counters
- Energy harvesting
- ESD security
- IGBT drivers and bridges
- Interface systems
- LED drivers
- Logic converters
- Memory
- Microcontrollers
- Optotriacs and optocouplers
- Other
- PLL generators
- Power systems
- Programmable systems
- Resetting systems
- RF systems
- RTC systems
- Sensors
- SoC systems
- Timery
- Touch sensors
- Transistors
- Sensors
- Accelerometers
- Air humidity sensors
- Air quality sensors
- Current sensors
- Distance sensors
- Flow sensors
- Gas sensors
- Gyroscopes
- Hall sensors
- Humidity sensors
- Infrared sensors
- Light and color sensors
- Liquid level sensors
- Magnetic sensors (compasses)
- Medical sensors
- Motion sensors
- PH sensors
- Position sensors
- Pressure sensors
- Pressure sensors
- Reflection sensors
- Sensors 6DOF/9DOF/10DOF
- Sensors of liquid quality
- Temperature sensors
- Vibration sensors
- Sound transducers
- Switches and buttons
- Cables
- INTERNET OF THINGS (IoT)
- MECHANICS
- POWER
- R/C MODELLING
- RASPBERRY PI
- Accessories for Raspberry Pi
- Audio video cables for Raspberry Pi
- Case Raspberry Pi
- Cooling for Raspberry Pi
- Displays for Raspberry Pi
- Extension modules for Raspberry Pi
- Memory cards for Raspberry Pi
- Power for Raspberry Pi
- Raspberry Pi 3 model A+
- Raspberry Pi 3 model B
- Raspberry Pi 3 model B+
- Raspberry Pi 4 model B
- Raspberry Pi 400
- Raspberry Pi 5
- Raspberry Pi cameras
- Raspberry Pi Compute Module
- Raspberry Pi model A/ B+/2
- Raspberry Pi Pico
- Raspberry Pi prototyping
- Raspberry Pi Zero
- Raspberry Pi Zero 2 W
- RETIRED PRODUCTS
- ROBOTICS
- SALE
- SOFTWARE
- STARTER KITS, PROGRAMMERS, MODULES
- Alchitry FPGA
- Altera FPGA
- Analog electronics
- Atmel SAM
- Atmel Xplain
- AVR
- Banana Pi
- BeagleBone
- chipKIT
- Coral
- CPLD Xilinx
- Cubieboard
- DFRobot FireBeetle
- Feather
- Freedom (Kinetis)
- FriendlyELEC
- HummingBoard
- Intelligent clothes
- Kit with a book
- LattePanda
- LPC (NXP)
- M5Stack
- Micro:bit
- Nvidia Jetson
- Odroid
- ODYSSEY
- Orange Pi
- Other development kits
- Peripheral modules
- PIC
- Raisonance
- Raspberry Pi RP2040
- RFID
- RISC-V
- SBC Embest
- SBC MYIR
- SBC others
- SBC UDOO
- Segger programmers
- SoMLabs
- Sparkfun MicroMod
- STM32
- STM32 Discovery
- STM32 MP1
- STM32 Nucleo boards
- STM8
- Teensy
- Universal programmers
- WRTNode
- Xilinx FPGAs
- WORKSHOP
- Adhesives and gluers
- Anti-static mats (ESD)
- Chemistry
- CNC milling machines
- Crimping tools
- Dispensing needles
- Drills
- Files
- Generators
- Handles, magnifiers
- Heat-shrink tubing
- Insulation strippers
- Keys
- Knives and scissors
- Laboratory power supplies
- Laminates
- Measuring devices
- Mikroskopy
- Mini drills and grindrers
- Organizers
- Oscilloscopes and accessories
- Pliers and pincers
- Power tools
- Riveting tools and rivets
- Screwdrivers
- SMD Accessories
- Soldering
- Tapes (aluminum, kapton, copper, insulating)
- Tweezers
- Ultrasonic cleaners
- Vices
- 3D PRINTING
New products
New products
zł42.46 tax excl.
Board with WiFi Espressif ESP32-S2 module and 0.96" LCD display. It offers 4 MB Flash memory and 8 MB SRAM. Leads are compatible with HAT modules for Raspberry Pi Pico. Waveshare ESP32-S2-LCD-0.96
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
Board with WiFi Espressif ESP32-S2 module equipped with 4 MB Flash memory, 8 MB external PSRAM memory and integrated WiFi 802.11 b/g/n transceiver. On the board there is a 3.3 V converter with current efficiency up to 1.8 A, an IPS LCD display with a diagonal of 0.96" and a ceramic WiFi antenna. The user has analog inputs as well as I2C, UART and SPI interfaces on 26 GPIO pins. The layout of the pins and the raster is compatible with HAT modules dedicated to the Raspberry Pi Pico, thanks to which the user can use a wide range of available extension modules. The programming board uses a USB type C connector.
1. ESP32-S2FH4 | 7. Pinout |
2. APS6404L-3SQR-SN 8MB PSRAM | 8. USB typu C Connector |
3. DC-DC 3,3V TPS63000DRCR | 9. BOOT |
4. Charge manager ETA6096 | 10. RESET |
5. Battery connector MX1.25 | 11. LCD IPS 0,96" |
6. WiFi antenna |
Thanks to the hardware cryptographic accelerator, RNG, HMAC and the digital signature module, the board offers great potential in the field of IoT systems. It can also be programmed using the Arduino IDE, ESP-IDF or CircuitPython. Full documentation is available on the product page.
Features
- 240MHz 32-bit single-core processor
- 4 MB SPI Flash Memory
- 8 MB of additional PSRAM
- 2.4 GHz Wi-Fi - 802.11b/g/n
- Ceramic antenna
- DC-DC converter 3.3 V 1.8 A
- Optimized power system ensuring low energy consumption
- Power supply: USB type C
- Built-in full speed USB OTG interface, LCD interface (8-bit serial RGB/8080/6800), TWAI controller (ISO11898-1 compliant), GPIO capacitive sensor, temperature sensor and RMT (TX/RX)
- 0.96 "IPS LCD Display
- 3.7V lithium battery charging circuit and MX1.25 connector
- 26 GPIO pins including ADC, UART, SPI, I2C
- The pinout is compatible with Raspberry Pi Pico HAT modules
- Dimensions: 54 x 21 mm
You might also like
Cable with USB typ A and USB typ C connectors, cable length 0.5 m. LANBERG
Cable with USB typ A and USB typ C connectors, cable length 1 m. LANBERG CA-USBO-10CC-0010-BK
Cable with USB typ A and USB typ C connectors, cable length 1,8 m. LANBERG CA-USBO-10CC-0018-BK
A pin expander for Raspberry Pi Pico boards. It is equipped with a standard female connector and four sets of male strips 2x20 pins. Waveshare Pico-Quad-Expander
A pin expander for Raspberry Pi Pico boards. It is equipped with a standard female connector and two sets of male strips 2x20 pins. Waveshare Pico-Dual-Expander
A pin expander designed for Raspberry Pi Pico boards. It is equipped with a standard female connector and four sets of male strips 2x20 pins. Pimoroni PIM555
Other products in the same category (16)
Module with a 4-inch touch display that uses two MCU systems (ESP32-S3 and RP2040) and supports Wi-Fi and BLE communication. The board is equipped with USB Type C, I2C (Grove) and analog inputs interfaces and can easily connect to other peripheral devices. Seeed Studio 114993068
No product available!
Board for applications in the area of the Internet of Things (IoT). The module is based on the ESP-WROOM-32E system with 240 MHz clock, equipped with 4 MB Flash and 520 KB SRAM, as well as WiFi and Bluetooth communication. DFRobot DFR0654
No product available!
Function module designed for MicroMod boards. It allows you to add WiFi wireless communication based on the ESP32 chip to the project. SparkFun WRL-18430
Espressif ESP32-S3 WiFi and Bluetooth LE module board. It offers 16 MB of flash memory and 2 MB of SRAM. The pinouts are compatible with the HAT modules for the Raspberry Pi Pico. Waveshare ESP32-S3-Pico
M5Stack series development kit equipped with ESP32-PICO-D4. It will work in IoT-related projects, as a STEM educational module or in Smart Home devices. M5Stack K051-B
Module with WiFi and BLE Espressif ESP32-S3. It integrates a LiPo charging circuit and an RGB diode. Adafruit 5398
No product available!
Adafruit HUZZAH32 is a development board with a built-in WiFi ESP32 module. Processor frequency: 240 MHz, the module has a built-in system for charging Li-Pol batteries. The plate has soldered goldpin connectors (female extension). Adafruit 3619
Board with WiFi and Bluetooth Espressif ESP32-C3 module. It offers 4MB Flash and 400KB SRAM and a LiPo charging circuit. The set includes an expansion board with a display connector. DFRobot DFR0868
Module with WiFi and Bluetooth Espressif ESP32 WROOM. It integrates a set of peripheral devices - capacitive touch sensors, Hall sensors, SD card interface, Ethernet, fast SPI, UART, I2S and I2C. SparkFun WRL-15663
A board with an ESP32 module equipped with a 1.28-inch touch screen. It offers Wi-Fi and Bluetooth 5.0 communication and has a built-in 6-axis QMI8658 IMU sensor and supports charging lithium batteries. Perfect for developing IoT, mobile devices and wearable electronics projects. Waveshare ESP32-S3-Touch-LCD-1.28
No product available!
Development board with ESP32 chip with WiFi and Bluetooth communication. Equipped with a microSD card slot, USB Type-C connector for programming and Ardunio Uno Rev3 compatible connectors and Qwiic connector. SparkFun WRL-19177
A set with a Doppler radar module and an XIAO ESP32C3 board designed for precise detection of human presence. It allows you to connect additional Grove sensors (analog or with an I2C interface) and expand the functionality. Seeed Studio 110061541
Espressif ESP32-S3 WiFi and BLE chip module with 1.14" TFT LCD display. It integrates a LiPo charging circuit and an RGB diode. It is equipped with a STEMMA QT connector. Adafruit 5691
No product available!
Development kit with ESP32 module and LoRa communication. It is equipped with an integrated ESP32-C3 chip with a 32-bit RISC-V core processor and a Wio-E5 STM32WLE5JC module as a long-range controller that supports the LoRa protocol. Seeed Studio 114992985
Advanced module with a 32-bit, single-core RISC-V processor. It has a built-in Bluetooth LE 5 and IEEE 802.15.4 (Thread, Zigbee 3.0) module. Perfect solution for IoT (Internet of Things) projects. Version with connectors for selfassembly. Waveshare ESP32-H2-DEV-KIT-N4
No product available!
Board with the WiFi ESP-12F (ESP8266) module and a 5 V relay. Equipped with an AC adapter