Gravity: 8-Digital LED Segment Display Module - 8-digit LED segment display (green)

Module with an analog AC current sensor in a set with a probe for non-contact measurement of alternating current with a current of up to 5A. DFRobot SEN0287

Radio receiver module operating at 433 MHz. It is equipped with Gravity connectors and communicates via a digital interface. DFRobot TEL0142

I2C multiplexer module with TCA9548A system. Allows you to connect up to 8 devices. The system works like a gateway - it transmits I2C interface data to one of the 8 main busses. This allows you to connect up to 8 devices with the same address. DFRobot DFR0576

Micro:Mate is an expansion board for the micro: bit development module. It provides six 3-pin connectors with I/O outputs, a 3.5mm audio jack connector and is powered from a 5V microUSB connector. DFRobot DFR0518

Module with an analog TEMT6000 light intensity sensor. The voltage at the output is linearly correlated with the intensity of the incident light. The module is supplied with the voltage from 3.3 to 5V. DFRobot SEN0043

Ring light with 16 RGB diodes WS2812B type controlled by serial signal. The module can be powered with the voltage from 3.3 V to 5 V, only one signal line is required to control it. DFRobot DFR0888-16

I2C BME680 Environmental Sensor is a gas, pressure, temperature and humidity sensor in one MEMS housing. The module is supplied with 3.3-5V, for communication the I2C or SPI interface is used. DFRobot SEN0248

DFRobot SEN0209

Air quality sensor module based on the ENS160 system. It communicates via the I2C interface (Gravity connector). DFRobot SEN0514

Extension cord for servo. It allows the servo cable to be extended by 300mm. DFR FIT0033

A set with a measuring module and a probe for measuring the pH of the solution. It is supplied with the voltage of 3.3 to 5.5 V. It has an analog Gravity output interface. DFRobot SEN0161-V2