OP20-1G - 20X tip for SigOFIT Micsig probe

BNC connector cable (adapter) for minigrabber clips. It enables the connection of the tested system with an oscilloscope

Test probe tip with 2000X attenuation factor. Dedicated to Micsig probes from the SigOFIT series operating in the 800 MHz and 1 GHz frequency band. Micsig OP2000-1G

A 20:1 signal attenuator designed to assist in measuring automotive performance, including measuring fuel injector and primary ignition runs. Hantek HT201

Test probe tip with 50X attenuation factor. Dedicated to Micsig probes from the SigOFIT series operating in the 350 MHz and 500 MHz frequency bands. Micsig OP50-5

Oscilloscope probe with BNC plug with 100MHz bandwidth. Uni-T UT-P04

The P2150 oscilloscope probe with a 150 MHz bandwidth and BNC connector ensures high signal integrity and wide bandwidth, featuring switchable attenuation of 1X/10X and an input resistance of 1 MΩ/10 MΩ ±2%. The set includes accessories such as a compensation tool, identification rings, and a hook clip for easier use.

BNC connector adapter cable for mini-grabber clips. Connects to Analog Discovery 2 via a BNC adapter. Digilent 240-136

A universal oscilloscope probe with a BNC connector and a 10:1 voltage divider. It has a frequency response of 60 MHz and allows measurements with a maximum voltage of up to 600 V. Hantek PP-80

The Micsig DP series differential probe is based on advanced metal shielding technology. It offers a 100 MHz frequency bandwidth and the ability to measure voltages up to 7000 V. It uses the popular BNC connector and is powered by a USB Type-C connector. Micsig DP7000

High-voltage differential probe. It has good measurement characteristics: a bandwidth of 100 MHz and an operating voltage of up to 1300 V. The probe has two attenuation coefficients: 50X and 500X. Hantek HT8100

LCRkelvin is a four-wire Kelvin probe for precise measurement of RLC components with minimal wire resistance impact. Equipped with gold-plated Kelvin clips, it ensures accuracy and reliability, and its design is compatible with LCR meters from various brands, such as Hantek and Uni-T

Cable (adapter) of a BNC connector to banana plugs. Allows convenient connection of a device to an oscilloscope, for example. BNC Q9

Professional oscilloscope probe, ideal for precise signal measurements. Hantek PP-150B

BNC connector cable (adapter) to the "Alligator clip" connector. It allows you to conveniently connect the device, e.g. to an oscilloscope. Digilent (240-134)

A probe tip with attenuation factor of 10000X. Dedicated to Micsig probes from the SigOFIT series operating in the 500 MHz frequency band. Micsig OP10000-5

6-wire test leads that allow the oscilloscope to be connected to various components in the engine compartment without stripping or puncturing the insulation and without risking damage to the connectors. Hantek HT306-1.5mm