Bluetooth Audio Receiver and Playback Module (Bluetooth 4.0)

Bluetooth audio receiver module that allows wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm Jack audio connector

Mini MP3 player with microSD card support. It can work as a separate device and play sounds from the card or be controlled via the UART serial interface.

Module with VS1000D chip and SPI Flash memory, which allows you to play sounds in Ogg Vorbix and WAV format stored on a SPI Flash memory. SparkFun DEV-14006

Module with a multi-channel WAV player. It allows you to mix 32 mono or 18 stereo tracks with the ability to connect to any MIDI controller. It has 8 mono or 4 stereo audio outputs. SparkFun WIG-18159

Bluetooth audio receiver module with microphone in set with 3.5 mm Jack adapter. It enables wireless transmission of sounds. It is equipped with a 3.5 mm audio jack, microUSB socket and a control button

Mini MP3 player with microSD card support. It can work as a separate device and play sounds from the card or be controlled via the UART serial interface. DFRobot DFR0299

Bluetooth 4.2 audio receiver with 5W stereo amplifier per channel. It allows you to play files via Bluetooth interface and supports WAV, APE, MP3 and FLAC formats. MH-M38

Audio receiver with Bluetooth 5.0 communication based on the QCC3008 module. It can be powered with the voltage from 3.6 V to 5.5 V, including with a lithium battery

Bluetooth 4.1 audio receiver with 3.5mm Jack audio output. It allows you to play files via Bluetooth, from a mass memory (flash drive) or from a microSD card. XY-BT

Qwiic Tsunami Super WAV Trigger - a module with a multi-channel WAV player

Bluetooth 4.1 audio receiver with 3.5mm Jack audio output. It allows you to play files via Bluetooth, from mass memory (pendrive) or microSD card and supports WAV, APE, MP3 and FLAC formats. XY-BT-L

This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381

An audio module with a DAC converter designed to work with the Raspberry Pi. Supports I2S/DSD/Coaxial input, Analog/Coaxial/Optical/I2S output, and has 384K/32Bit decoding function. DFRobot DFR0941

Audio module with DAC, line output and display, designed to work with the Raspberry Pi. Pimoroni PIM483

Adafruit 2342

Audio module with DAC, amplifier, display and loudspeaker, designed to work with the Raspberry Pi. Pimoroni PIM485