eMMC memory module with Linux for Odroid N2L - 16GB

Grapic LCD 128x64, 93x70mm, with backlight (yellow/green), ST7920 controller, character generator, 8bit, 4bit and serial interface

The eMMC 5.1 flash memory module for Hardkernel Odroid XU4 computers. 128GB capacity, installed Linux operating system. The set includes a microSD adapter. Hardkernel

DCC CONTROL PANEL NANOX - PLATE INCLUDED AND PROGRAMMED

3-pin ARK mounting strip, 5.0 mm pitch. 301-5.0-03P-12-00A(H)-RD

The case is made of ABS, designed for Raspberry Pi Zero W minicomputers. The user has free access to all minicomputer ports, including the GPIO connector

Infrared sensor that allows measurement of distances up to 15cm, has a built-in infrared illuminator, IR receiver and a perimeter of the received signal

PCB board and programmed circuit for a simple digital thermostat. AVT1878 A +

Considering safe-cracking as a profession? This might be just where you should start. Build your own safe with a personal lock combination, store your most precious items in the safe (jewelry or candy, your choice), and then promptly forget your combination! UGears 70011

Twisted housing, dedicated to the Orange Pi Zero computer. The housing protects the computer against dust, accidental short circuits and mechanical damage. Properly prepared holes allow you to use all the sockets that Orange Pi Zero has been equipped with.

EXPANSION MODULE FOR RASPBERRY Pi. INTERFACE OF CONTACT PLATE - PLATE

Module with a 3-axis ADXL356B accelerometer with a measuring range up to ± 20g. The board is equipped with a Grove connector and communicates via the analog interface. Seeed Studio 101020637

CO2 sensor module with MG811 system with a voltage of 6 V. The module has an analogue output of 30 ... 50mV and TTL

Oualline Steve