Arduino LilyPad Programming Cable

The module of the SD and MMC memory card reader ("large") with the card lines led out to the 2.54 mm connector mounting area /. It allows easy connection of the SD card to the project being built. BOB-12941

The light line has 8 LEDs type WS2812 - thanks to the built-in controller, it is possible to connect the strips in series and control them with one signal cable. NeoPixel Stick 8 x WS2812

SIMPLE LAMP PREAMPLIFIER - PRINTED PLATE

UMTS/HSDPA Module, RoHS

Orange Pi 3 1GB is a mini-computer equipped with SoC Allwinner H6 (quad-core, frequency up to 1.8 GHz, 64-bit architecture, ARM Cortex ™ -A53 core). It has 1GB RAM (LPDDR3), Mali T720 graphics. On the board you can run Android 7.0 and Linux (Ubuntu, Debian).

Alphanumeric display OLED 4x20, with built-in controller WS0010, communicating via 6800 interface, optionally 8080 or SPI. Winstar WEH002004AB

Development kit with STM32F107 microcontroller and ST802RT1A ethetnet controller.

Filament from ROSA3D made of high-quality PLA pellets. Placed on a cardboard thimble, on which 1 kg of 1.75 mm diameter filament is wound. ROSA3D ReFill PLA Starter Grey

Intelligent Wi-Fi plug. It automatically controls lighting, heating and any other connected electrical appliance. Shelly Plug S

Kit for building an intelligent JetBot robot based on Jetson Nano. It consists of Jetson Nano with 2GB RAM, expansion module, WiFi card, camera, motors, housing and a set of mounting screws. JetBot AI Kit (USB WiFi) 2GB