- Out-of-Stock

PCB02A 8-pin PIC prototyping PCB
This printed circuit board is designed for building your own circuits based on Microchip Technology’s line of 8-pin PIC microcontrollers. The board holds a PIC and the basic circuitry necessary to run it. The rest of the board is available for your custom circuits.
The Pololu 8-pin PIC prototyping printed circuit board (PCB) is ideal for small electronics projects based on 8-pin PIC microcontrollers from Microchip Technology. Part of the board is designed to hold an 8-pin PIC, a voltage regulator circuit, and a crystal or resonator with capacitors. All of the PIC I/O lines, power, and ground are brought out for easy access. The rest of the board consists of a prototyping area with an 11 x 12-hole grid and a DB9 connector footprint (hole pattern).
The prototyping grid has pads connected in pairs and triplets, and two bus lines, keeping your circuit neat and compact, making this prototyping PC board an elegant alternative to breadboards for any small 8-pin PIC project.
![]() |
Pololu USB-to-Serial Adapter |
![]() |
PCB01A 5" Round Prototyping PCB |
![]() |
0.100" (2.54 mm) Breakaway Male Header: 1x40-Pin, Straight |
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
No product available!
Velleman kit for self-assembly of an ultrasonic bats detector. K8118
No product available!
No product available!
RoboClaw 2x160A Motor Controller is a two-channel DC motor driver, operating voltage: 10.5..60V, maximum continuous current: 120A, easy implementation of feedback loops with PID controller, safety systems. Pololu 3582
No product available!
No product available!
No product available!
No product available!
Kit for building a minisumo robot on a crawler chassis. It has a bulldozer, control board and a set of caterpillars. Robot version for self-assembly, requires additional motors and four AA batteries. Pololu 3124
No product available!
RF remote transmitter with USB port - set for self-assembly
No product available!
A module that allows you to connect ArduCAM cameras with a CSI interface to a PC or minicomputers via the USB3.0 interface. It not only supports high-resolution, high-frame rate image sensors, but also a stereoscopic camera and IRCUT control functions. ArduCAM B0111
No product available!
No product available!
Li-Po battery 3.7V / 320mAh, PCM safety, connector + JST-BEC 2,54 socket, 2 pins, cable length 150mm
No product available!
No product available!
No product available!
Permanent cylindrical neodymium magnet with a diameter of 8 mm and a height of 10 mm.
No product available!
No product available!
PCB02A 8-pin PIC prototyping PCB