- Out-of-Stock
AVT595 A
ID: 208727
SPI INTERFACE FOR PUNCH PROGRAMMER - PRINTED PLATE
SPI INTERFACE FOR PUNCH PROGRAMMER - PRINTED PLATE
Producer: AVT
Producer: AVT
The SPI adapter is intended for the PUNCH programmer ( AVT5092 ) and is used to expand the capabilities of this tool. Thanks to it, PUNCH can program various types of microcontrollers mounted in the target system equipped with Flash memory. The recording of new data takes place in direct mode, when the processor is mounted on the target board.
The adapter includes a number of three-state gates and transistor keys. This allows you to adjust the signal levels to a specific type of programmable system.
The device is recommended for all users of the PUNCH programmer
Selected parameters:
- AT90S2313, AT90S515, ATMEGA515, AT89S52, AT89S8252 support
- the ability to develop scripts to support other microcontrollers
- power supply - 5 V
- printed circuit board and documentation included
A detailed description in EP 10/04
208727
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
A surface speaker with an impedance of 8 Ω and a power of 1 W. It is made of a voice coil attached to a pad that conducts vibrations. SparkFun COM-10917
Retired
No product available!
No product available!
Extension for Raspberry Pi; communication module with RS-485 interface (DEV-13000). Module with the possibility of mounting the DB-9 socket, the socket should be purchased separately
Retired
No product available!
(FIT0326) 7" Diagonal - 1280x800 IPS HDMI/VGA/AV Display
Retired
No product available!
No product available!
No product available!
PCB board and programmed layout for the dawn and twilight simulator. AVT5480 A +
Retired
No product available!
Car charger G50D is a practical solution for users looking for an efficient and safe power source while traveling. Thanks to fast charging, a multi-port design, and compatibility with 12 V and 24 V voltage, it works well in both passenger and commercial vehicles. Its aesthetic and compact design makes the charger not only look good but also meet the expectations of even the most demanding users.
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
A set of basic electronic components complete with contact plate, connecting cables and Arduino UNO R3. It is ideal for beginner electronics who also know Arduino. ArduCAM KB0001
Retired
No product available!
The eMMC 5.1 flash memory module for Hardkernel Odroid C2 computers. 8GB capacity, Android operating system installed. The set includes a microSD adapter. Hardkernel
Retired
No product available!
BOB-09168 - OSD development board on the MAX7456 chip, Sparkfun
Retired
No product available!
Patchcord UTP 5E Ethernet cable with a length of 5 m - gray, with 2xRJ45 connectors
Retired
No product available!
SPI INTERFACE FOR PUNCH PROGRAMMER - PRINTED PLATE