Casing for Cubieboard 1 and Cubieboard 2 transparent

3D printer, PLA / ABS / others up to 250 ° C (1.75 mm), LCD, SD, Impulsator, assembly set, RoHS

What you need is an add on prototyping T-breakout board, which can break out all those tasty power, GPIO, I2C, ADC pins from the 40 pin header onto a solderless breadboard. This set will make "cobbling together" prototypes with the ODROID-C1 super easy

BLUE RELAY - PLATE IN PRINTED AND INVITED

Graphic LCD 128x64, 54x50m, EL backlight (white), Pb-Free, FSTN positive, 4 pictograms instead of first 4 rows, low power consumption

Needle bending needle, for precise glue application, Flux 1,194mm internal diameter and 1,651mm outside diameter

cu03w-p-220-00

Solarbotics GMB39 (GM3/GM9 Gear Motor Bracket, Laser-Cut Steel)

Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table

50 MHz Sampling rate 1M Pts per channel For serious Hobbyists

Evaluation kit with LittleBee GW1N-1 FPGA chip. Offers 1152 LUTs and 864 Flip-Flops (FF). The board has an FPC connector for the display and a USB type C. Sipeed Lichee Tang Nano