- Out-of-Stock

1.75 mm PVA filament for 3D printing by ROSA3D. 0.5 kg of filament is wound on the spool. The recommended printing temperature is in the range of 190°C to 215°C, and the temperature of the bed during printing in the range of 50°C to 70°C, however, when using adhesives, heating the bed is not necessary.
Rosa3D is a Polish manufacturer of filaments intended for both hobby and industrial printing. Thanks to many years of experience and modern machinery, the company is able to provide good quality and high accuracy of the diameter and roundness of the filament.
PVA filament (polyvinyl alcohol) is a water-soluble thermoplastic. It is perfect as a support material in complex prints made of other materials. By using PVA on a two-head printer, you can print models that would otherwise require printing in parts, gluing or would not be feasible at all. After the printing is finished, it is enough to immerse the model in warm water (but not exceeding the temperature of thermal deformation of the filament from which the actual part of the print is made). Depending on the dimensions of the model and the amount of PVA used, such a bath may take from several minutes to several hours. Mixing the water in the tank can speed up the dissolution process of the supports.
PVA is printed at low temperatures, in an open printer and an unheated bed. Due to its strong hygroscopicity, the filament must be stored in a tightly closed bag or container with a moisture absorber. Storing PVA away from sunlight and at a temperature between 15 ° C and 25 ° C will extend its service life.
3D printer with dual color print and heated table. The printer is fully assembled and ready to use. Flashforge Creator PRO
Adhesive increasing the adhesion of 3D prints to the glass table. It makes it easier to work with all materials and prevents undesirable curling of the elements. Dimafix Spray 400ml
Adhesive increasing the adhesion of 3D prints to the glass table. It makes it easier to work with all materials and prevents undesirable curling of the elements. Dimafix Pen 90ml
3D printer with two extruder and a heated table. It is fully assembled and ready to use. Flashforge Creator Pro 2
No product available!
ADMP401 MEMS Microphone Breakout Board
No product available!
No product available!
DS100B - converter module RS232 / 422/485 Ethernet 10BaseT
No product available!
Module with a current and voltage sensor. Can measure voltage up to 26 V and current up to 3.2 A. Based on INA219 sensor, I2C communication. SparkFun SEN-15176
No product available!
8-CHANNEL TEMPERATURE TEMPERATURE SYSTEM WITH USB - PRINTED PLATE AND PROGRAMMED SYSTEM
No product available!
No product available!
Aluminum housing designed for Raspberry Pi B + / 2B / 3B / 3B +. Black colour. RB-ALUcase + 01
No product available!
No product available!
No product available!
No product available!
No product available!
PCB for an economic logarithmic probe. AVT1962 A
No product available!
Kit: ZL10PLD + ZL9PLD + book "FPGA chips in examples" + SilicaProg
No product available!
No product available!
The ICE40HX1K-STICK-EVN is an easy to use, small size board that allows rapid prototyping of system functions at a very low cost using iCE40 FPGA. This board has a high performance, low power iCE40HX1K FPGA onboard and has a USB thumb drive form factor.
No product available!
ROSA3D filament made of high-quality water-soluble PVA. 0.5 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PVA Natural