- Out-of-Stock
Class A tube preamplifier based on 6J1 tubes. It allows you to change the volume by means of a potentiometer and give a "sweet" sound color characteristic for devices with vacuum tubes. The preamplifier allows you to connect two audio input channels via RCA connectors and outputs in the form of a power amplifier. It is powered with the voltage of AC 12 V.

Due to the standard sockets, the user can replace the tubes with other ones to modify the preamplifier operating parameters. The electronic module was placed in an acrylic housing. The device is a good choice for both novice users and audiophiles.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
HiFi stereo tube amplifier based on 6J1 and 6P1 tubes. Designed for use with loudspeakers up to 3 W and an impedance of 4 Ω or 8 Ω
A stereo tube preamplifier based on 6K4 tubes. Designed for use with active speakers or an additional amplifier and passive speakers. SUCA-AUDIO TUBE-T1
No product available!
No product available!
No product available!
Shielded FTP category 5E Ethernet network cable with RJ45 plugs. Lanberg PCF5-10CC-0500-O
No product available!
Orange Pi Plus is a computer with SoC Alwinner H3 (4 cores Cortex-A7, Mali400MP2 GPU), 1 GB RAM, 1 Gb Ethernet, WiFi 802.11 b / g / n. There are 4 USB 2.0 ports, a USB OTG port, a GPIO 2x20 connector compatible with Raspberry Pi 2 and a micro-SD card slot, 8GB EMMC Flash
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Green, aluminum case for Raspberry Pi 4 model B. It has been equipped with mounting holes of the VESA 75 standard
No product available!
Cable with USB plugs type A and micro-USB type B, cable length 1m. The cable has a yellow nylon braid
No product available!
No product available!
No product available!
This compact, inexpensive plastic gearmotor (brushed DC motor with a 120:1 reduction gearbox) is well suited for use in small robots. While intended for operation at 4.5 V, it should run comfortably in the 3 V to 6 V range.
No product available!
No product available!
Constant voltage transducer for pulse width - a self-assembly set
No product available!
Class A tube preamplifier based on 6J1 tubes. Designed for use with an additional power amplifier. Powered by AC 12 V