KAmod BlackPill 401 - Evaluation board with STM32F401CCU microcontroller, compatible with BlackPill
search
  • KAmod BlackPill 401 - Evaluation board with STM32F401CCU microcontroller, compatible with BlackPill
  • KAmod BlackPill 401 - Evaluation board with STM32F401CCU microcontroller, compatible with BlackPill
  • KAmod BlackPill 401 - Evaluation board with STM32F401CCU microcontroller, compatible with BlackPill
  • KAmod BlackPill 401 - Evaluation board with STM32F401CCU microcontroller, compatible with BlackPill
ID: 1193741
5906623490486
zł34.80
Tax included

zł28.29 tax excl.

The KAmod BlackPill 401 is an evaluation board featuring the STM32F401CCU microcontroller, equipped with a USB-C connector with ESD protection and a modified power circuit. With a pre-installed bootloader, it supports Arduino IDE, offering 32 GPIOs and versatile programming and communication capabilities

24h
Available
Available quantity: 258
KAmod BlackPill 401:
Standard
Soldered joints from the bottom Soldered joints from the above

Description

The KAmod BlackPill 401 evaluation board features the STM32F401CCU microcontroller and includes all the components necessary for its operation and programming. While pin-compatible with the BlackPill project, this is a completely new design featuring a USB-C connector with ESD protection and a modified power circuit. With a pre-installed bootloader, it supports programming via Arduino IDE.

Features

  • Microcontroller: STM32F401CCU6: Cortex-M4, 256 kB Flash, 64 kB RAM, 84 MHz, 1 x 12-bit ADC, 7 timers, 3 x I2C, 2 x SPI, 3 x UART, USB OTG FS, RTC.
  • USB-C Connector: Functions as a power supply, USB communication interface, and programming port.
  • Noise and surge protection: Includes filtering components for USB interface lines.
  • GPIO and power lines: 32 GPIO pins and 5V/3.3V power lines available on 2.54 mm pitch connectors.
  • Load capacity: 5V line: 500 mA; 3.3V line: 200 mA.
  • Clocking: Precise resonator for the microcontroller and a separate resonator for RTC.
  • RTC backup: Supports an external battery for RTC backup.
  • Programming/Debugging Interface: SWD interface for advanced programming.
  • Compatibility: Programmable via STM32CubeProgrammer and Arduino IDE.
  • Dimensions: 53.5 x 23 mm; height approx. 7 mm (without soldered goldpin headers).

Included

  • Fully assembled module with pre-installed bootloader.
  • 2x 20-pin straight goldpin headers (2.54 mm pitch).
  • 1x 4-pin angled goldpin header (2.54 mm pitch).
1193741

Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20

Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20

Other products in the same category (16)