Bidirectional converter of voltage levels 3.3V/5V

BOB-12009

8-channel voltage level converter module with an input voltage of 12 V and an output voltage of 3.3 V. Unidirectional, based on resistor dividers. Numato Lab NLVD00008

Analog voltage divider module. It enables a 5-times reduction of the input voltage. DFRobot DFR0051

BOB-11771 Voltage-Level Translator - TXB0104 Breakout

Module with a voltage divider. Equipped with a Grove connector, it allows the input voltage to be reduced by 3 or 10 times. Seeed Studio 104020000

Module with a voltage level converter 3.3 V - 5 V intended for use in the Qwiic system. It has a built-in Step Up converter providing power supply with a voltage of 5 V and a current of up to 100 mA. SparkFun SPX-17238

A module enabling the conversion of input voltage in the range from 1.8 V to 5.3 V into the appropriate negative output voltage. It offers high efficiency in excess of 80%, making it ideal for applications where a lower power negative supply is required, such as biasing sensors or op-amp circuits. Pololu 2839

Bi-directional 8-channel logic level converter module (1.2-3.6V to 1.7-5.5V) based on TXS0108 chip.

The module with the four-bit logic translator TXB0104, can work in both directions. Connections using standard goldpin connectors with 2.54 mm pitch. It is compatible with BOB-11771

8-channel voltage level converter allowing for connection of systems operating with the voltage level of 1.8 V, 2.5 V, 3.3 V and 5 V. SparkFun BOB-19626

A module with a set of resistors and mechanical switches that allows you to adjust the resistance in the range from 0 to 999990 Ω. SparkFun KIT-13006

8-bit voltage level converter with TXB0108 integrated circuit. It acts as a bridge between applications with different source voltages and input and output voltage levels. SB Components 21772

Module with a 4-bit bi-directional voltage level converter. It allows you to connect digital interfaces with different operating voltages. KAmodNTS0104PW

A small module with a voltage level converter that allows easy conversion of signals from 3.3V to 5V. It is compatible with a wide range of LED strips, such as NeoPixel. With easy, solderless installation, it supports up to two signal lines, ensuring smooth operation of LEDs at frequencies up to 10 MHz. Adafruit 6066

Module designed to filter electrical signals. It uses an LC filter, which consists of a coil and a capacitor, to eliminate noise and unwanted components from the electrical signal. It can filter signals with voltages up to 30 V and currents up to 3 A

Voltage-to-current converter module designed for devices with a current signal input. It allows you to linearly convert voltage signals from 0 to 5 V into current signals from 0 to 20 mA