Category: RETIRED PRODUCTS

The case is designed for minicomputers Raspberry Pi 4 model B. Made of ABS, has a built-in heat sink and cooling fan. Waveshare PI4-CASE-POLY-WITH-MINI-FAN-KIT

Kit with 16 modules and the IO Expansion Shield designed to work with the Arduino Uno. Dedicated to learning programming and electronics

Development kit with ESP32 WiFi and Bluetooth module and 1.54 "ePaper display. Built-in IMU MPU6050 sensor and USB-UART converter. LilyGO TTGO T-Block ESP32

Programmable watch with ESP32-Pico-D4. Equipped with a touch button display, motion sensor, power management system, RTC clock and Lithium battery. LILYGO TTGO T-Wristband

Wrist strap for LilyGo TTGO t-wristband module. Black colour

Industrial DTU 4G module with Qualcomm SIM7600E-H chip. It allows you to connect industrial modules with serial communication via RS232, RS485 or TTL interfaces with 4G networks. Waveshare SIM7600E-H 4G DTU (EU)

QLED IPS 9" display with a touch screen and Quantum Dot technology. The display is equipped with an HDMI interface for image display and USB for the touch panel. Resolution 1280x720 pixels. Waveshare 9HP-CAPQLED

8 Mpx camera module with IMX219 sensor and wide-angle lens. To be used as a replacement on the RPI Camera Board V2. ArduCAM B0194

Module with 6-axis IMU motion sensor that combines a 3-axis accelerometer and a 3-axis magnetometer in one system. It communicates via the I2C bus. Pimoroni PIM376

Module with 6 5x7 LED matrix displays designed to work with the Raspberry Pi. It uses IS31FL3730 drivers and communicates via the I2C interface. Pimoroni PIM187

Module with 6 5x7 LED matrix displays designed to work with the Raspberry Pi. It uses IS31FL3730 drivers and communicates via the I2C interface. Pimoroni PIM187

A module with 5 buttons and an RGB diode, designed to work with the Raspberry Pi. The buttons are connected to the minicomputer through the GPIO expander controlled by the I2C interface. Pimoroni PIM301

Kit for controlling soil moisture of cultivated plants. It contains the HAT Mini module, soil moisture sensors and pots and seeds of herbs: basil, coriander and rosemary. Pimoroni PIM518

Kit for controlling soil moisture of cultivated plants. It contains the HAT Mini module, soil moisture sensors and pots and seeds of chilli. Pimoroni PIM519

A module with a spectrum sensor that operates in the visible light range (450-650 nm). It allows you to measure and characterize a light source or check how the tested surface absorbs or reflects light at specific wavelengths. Pimoroni PIM412

Module with a UV ultraviolet light sensor VEML6075. It enables measurement of the level of UVA (350-375 nm) and UVB (315-340 nm) radiation. It communicates via the I2C bus. Pimoroni PIM460

Module with two 5x7 LED matrix displays designed to work with the Raspberry Pi. It uses IS31FL3730 drivers and communicates via the I2C interface. Pimoroni PIM527

Starter kit with RedBoard development board and Qwiic modules: IMU, environmental sensor, GPS module, joystick, accelerometer, keyboard and proximity sensor, MP3 player, relay and OLED display. SparkFun KIT-16262

Module with two 5x7 LED matrix displays designed to work with the Raspberry Pi. It uses IS31FL3730 drivers and communicates via the I2C interface. Pimoroni PIM526

The system of a practical clock with an extremely simple design is equipped with a readable LED display, an alarm clock with a snooze function, and battery backup of the clock operation after a power failure