Category: RETIRED PRODUCTS

Wireless sensor containing a precise accelerometer and magnetometer (electronic compass) with built-in event memory (recorder)

Wireless sensor containing a precise accelerometer and magnetometer (electronic compass) with built-in event memory (recorder)

Wireless motion sensor and magnetic field with built-in event memory (recorder)

Wireless, accurate temperature and humidity sensor with built-in event memory (recorder)

AVT kit for self-assembling LEDs, contains a set of elements. AVT1844 B

Wireless, accurate temperature and humidity sensor with built-in event memory (recorder)

Connection of 5MPx camera with JPEG compression with full BLE functionality

The device allows the presence of devices with BLE in networks with Ethernet protocol, extends the range of sensors iNode Care Sensor

A wireless energy consumption monitor with built-in memory, thanks to the analysis of daily consumption, can help reduce the cost of electricity consumption

A wireless energy consumption monitor with built-in memory, thanks to the analysis of daily consumption, can help reduce the cost of water consumption

Flex Cable for Raspberry Pi Camera - 200mm / 8". Adafruit 1647

MYIR MYC-C7Z010 is a single board module based on the MYC-C7Z010 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.

LEGO 31313 Mindstorms EV3

The ADC module allows you to measure the voltage and provide the result in digital form, it has a built-in 4-channel ADS1015 transmitter. Modally MOD-55

The controller can control two brush motors, communicating with the master system using USB, TTL serial interface, analog signals, as well as signals from the RC apparatus. The current capacity of 15 A / channel allows you to control high-power motors. Pololu 2395

Pre-installed Android4.4 or latest version for ODROID-XU3 and XU4. Ready to run out of box 8Gbyte eMMC Version 5.0 interface from Toshiba. JEDEC/MMCA version 5.0:HS400 interface with 8bit DDR mode

Mini USB Bluetooth dongle compatible with ODROID-C1, C1+, C0, C2 and XU3, XU4

Works with the ODROID-C2 / C0 / C1+. The HiFi Shield provides both stereo RCA connectors and a 3.5mm stereo jack (all gold-plated) to connect to external amplifiers and other audio equipment

This rev of the RS232 Shield provides with the option to choose between two pins from an Arduino (D0 to D7) as software serial ports to communicate with RS232 Shield. DEV-13029

The HSPA / GSM modem card with the miniPCIe connector allows to obtain 14.4 Mbps "up" transmission speed and 5.76 Mb / s "down" transmission, working on four ranges. HUAWEI MU609