Category: STARTER KITS, PROGRAMMERS, MODULES

Module with 17x7 LED matrix display (119 LEDs) designed to work with micro:bit. It uses the IS31FL3731 driver and communicates via the I2C interface. Pimoroni PIM353

A set with a radio transmitter and receiver operating at 433 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 104020002

Module with 6-axis IMU sensor MPU6886, which combines a 3-axis accelerometer and a 3-axis gyroscope. M5Stack U095

The module with six touch buttons and LED diodes is designed for micro:bit. It uses the CAP1166 driver and communicates via the I2C interface. Pimoroni PIM401

Module with an EMG signal detector. The board is equipped with a Grove connector and has an analog output. Seeed Studio 101020058

Espressif ESP32-C3 WiFi module board. It offers 4 MB of Flash memory and 400 kB of SRAM, as well as an RGB diode. It is equipped with a STEMMA QT connector. Adafruit 5700

Camera module based on ESP32 integrated with 8 MB of PSRAM. The camera is equipped with an OV3660 sensor with a resolution of 3 MPx and WiFi communication. M5Stack U082-X

ESP32-S3-Touch-LCD-4B is a ready-to-install development board with ESP32-S3 and a 4" touch screen, intended for use in building automation, HMI systems and voice interfaces. The compact 86×86 mm format facilitates integration in wall enclosures and control panels.

Module with blue LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030010

5-port Hub with Grove connectors for M5Stack sets. It allows you to connect several devices with Grove connectors to the evaluation kit. M5Stack Grove-T

Module with white LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030009

GPS module with SAM-M10Q GNSS receiver. The chip can receive data from all major positioning systems: GPS, GLONASS, Galileo, QZSS and BeiDou. It has derived UART and I2C interfaces. SparkFun GPS-21834

Module with a digital temperature and humidity sensor based on the SHTC3 system. Communication takes place via the I2C interface. SparkFun SEN-16467

Module with 6-axis IMU LSM6DSO sensor, which combines a 3-axis accelerometer and gyroscope, as well as a 9kB FIFO buffer and event handling functions. Communicates via I2C or SPI. SparkFun SEN-18020

MicroMod main module with STM32 microcontroller. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SparkFun DEV-17713

The board is equipped with the STM32F405 microcontroller with the ARM Cortex-M4 core and SPI Flash memory, 20 GPIO pins, SD card slot, pins for connecting the battery with the charging and voltage stabilization circuit, JTAG connector and Qwiic socket. SparkFun DEV-17712

Module with green LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030007

Module with a digital temperature and humidity sensor based on the SHT31-F system. Communication via the I2C interface. Equipped with a Gravity DFRobot SEN0334 connector

Evaluation board with nRF52840 microcontroller and bluetooth communication. Equipped with motion, temperature, light, sound sensors and RGB diode. Compatible with micro: bit modules. Adafruit 4500

The STM32 Nucleo expansion board allows you to control a bipolar stepper motor. The maximum phase current is 2.8A RMS, the controller has overheat protection and overcurrent protection