Category: STARTER KITS, PROGRAMMERS, MODULES

A compact IoT device that combines an ESP32S3 processor with a Wio-SX1262 LoRa module, enabling communication distances of up to 5 km in the 868–915 MHz band. With support for LoRaWAN, 2.4 GHz Wi-Fi, Bluetooth 5.0, and expansion options for GNSS and sensors, it is a versatile solution for IoT gateways and nodes. Seeed Studio 102010611

Development board with NXP iMXRT1062 ARM Cortex-M7 microcontroller. Equipped with a microSD slot. Version without Ethernet communication. PJRC TEENSY41-NE

8-position DIP-Switch Module

WiFI 802.11 b/g/n module. Equipment includes, among others: LED diode, antenna, 8 pins with 2.54mm pitch (including 3 GPIO lines). Power supply: 3.3V.

Wi-Fi module based on the ESP8266 system - simplicity of use (communication through UART, supports AT commands), 3.3V power supply, support for WPA / WPA2 encryption - these features make the EPS8266 module applicable anywhere, where reliable and effective data transmission. The module is not equipped with an antenna, it should be attached using the U.FL connector. ESP-05

Base Shield V2 is an extension for tiles with an Arduino shield connector, it has a Grove connector, which can be connected to Grove-compatible modules / sensors. Seeedstudio 103030000

Pressure sensor module with I2C interface (MPL115A2)

STM32 Nucleo-64 development board with STM32F446RET6 MCU, supports Arduino and ST morpho connectivity

Compact tool for debugging and programming STM32 microcontrollers via JTAG / SWD interfaces. STMicroelectronics STLINK-V3MINIE

Development board D1 Mini with WiFi module ESP-8266MOD and 4 MB Flash memory. The module can be programmed from the Arduino IDE level. WeMos D1 Mini

Discovery kit based on STM32G431CB microcontroller, L6387 controller and STL180N6F7 MOSFET power transistors. Designed to drive a 3-phase brushless motor (BLDC/PMSM) and implement both sensorless FOC or 6-step algorithm. STMicroelectronics B-G431B-ESC1

Flexible Qwiic cable, 150 mm long. On one side it is terminated with a female Qwiic connector, and on the other side with single female goldpin connectors. SparkFun PRT-17261

STM32 Nucleo-64 development board with STM32L476RGT6 MCU, supports Arduino and ST morpho connectivity

Board with RP2040 microcontroller and W5100S network chip. The module is equipped with an Ethernet connector. WIZnet W5100S-EVB-Pico

Debugger/programmer with a USB interface that supports the SWD (Serial Wire Debbug) programming interface. It is based on CMSIS-DAP (Coresight Debug Access Port) and also has a USB-UART converter function

Development board based on a microcontroller with a RISC-V core. It offers support for WiFi 6, Bluetooth 5 and Zigbee 3.0 and Thread (IEEE 802.15.4) protocols. It uses the ESP32-C6-WROOM-1-N8 module and is compatible with ESP32-C6-DevKitC-1-N8. Waveshare ESP32-C6-DEV-KIT-N8

Multi-protocol module, SMD module ESP32-S3R8 with built-in 8 MB Octal PSRAM, 16 MB Quad SPI flash, and IPEX antenna connector.