Category: Peripheral modules
Subcategories
There are 966 products.
This V2 Rotation Sensor is arduino compatible multi-ring rotation sensor. It is based on multi-turn precision potentiometer. It can rotate upto 10 laps. DFR0058
Module with a pressure sensor DPS310 with high measurement accuracy. The board is equipped with a Grove connector and communicates via the I2C or SPI interface. Seeed Studio 101020812
Speech recognition module with Nuvoton ISD9160 system, microphone, Flash memory and speaker output. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 101020232
Two-button module with 4 colored overlays. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020103
A set with a measuring module and a probe for measuring the pH of the solution. It is supplied with the voltage of 3.3 to 5.5 V. It has an analog Gravity output interface. DFRobot SEN0161-V2
A set with a temperature sensor based on the DS18B20 system in the form of a waterproof measuring probe, a sensor adapter and a cable. Communication via the 1-Wire interface. DFRobot KIT0021
Module with a bistable button and red LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-R
Module with three optical inspection sensors (spectrophotometers) from the AS7265x series. The module consists of three sensors; AS72651, AS72652 and AS72653 which can detect wavelengths from 410nm (UV) to 940nm (IR). SparkFun SEN-15050
Pmod ESP32 is a module with the ESP-WROOM-32 system, allowing for WiFi communication, Bluetooth BLE 4.0 and Bluetooth. For communication, the SPI or UART interface is used (selected by means of the slide switch), which were output on the 12-pin Pmod connector. Digilent 410-377
Module with blue LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030010
Module with a button and re LED backlight. Controlled by the I2C interface, it has a built-in debouncing mechanism, pull-up resistors as well as interrupts and a FIFO queue. SparkFun BOB-15932
VL53L0X ToF Laser Range Finder is a laser distance sensor using the ToF (Time of Flight) measurement technique. The module is supplied with 3.3 ... 5 V voltage and can measure up to 2 m. DFRobot SEN0245
A module with a high precision temperature sensor based on the MCP9808 chip. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 5027
Module with a digital temperature and humidity sensor based on the SHT31-F system. Communication via the I2C interface. Equipped with a Gravity DFRobot SEN0334 connector
Gravity sensor adapter with 3-pin terminal connector. There are two 10 kΩ pull-up and pull down resistors on the board, set with a jumper. DFRobot DFR0055
Module with 5 A 250 VAC relay. DFRobot DFR0017
Module with OTP-538U non-contact temperature sensor. The board is equipped with a Grove connector and has analog outputs. Seeed Studio 101020062
A set with a radio transmitter and receiver operating at 315 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 113020001
Non-contact liquid level sensor with Gravity interface. It allows you to detect the level of liquid in non-metallic containers. DFRobot SEN0485
Soil moisture sensor with I2C interface. The probe has two pointed tabs, making it easy to insert into the ground. The sensor is supplied with the voltage of 3.3 V or 5 V. SparkFun SEN-17731