Category: Peripheral modules
Subcategories
There are 966 products.
Module with a SI1145 light sensor that can detect waves with a wide range of wavelengths: UV, visible and infrared light. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020089
Non-contact liquid level sensor with Gravity interface. It allows you to detect the level of liquid in non-metallic containers. DFRobot SEN0485
GrovePi + is an extension in the form of a HAT overlay intended for Raspberry Pi computers (B / B + / A + / 2/3/3 +). The module has 15 connectors to which modules / sensors compatible with the Grove standard can be connected. Seeed Studio 103010002
Gravity sensor adapter with 3-pin terminal connector. There are two 10 kΩ pull-up and pull down resistors on the board, set with a jumper. DFRobot DFR0055
ATECC608A cryptographic chip module. Enables adding strong security to an IoT node, edge device or embedded system. Adafruit 4314
Module with a joystick with two analog axes (X and Y axis) with a button (Z axis). The board is equipped with a Grove connector and has analog outputs. Seeed Studio 101020028
Module for RFID reader (125 kHz) equipped with I2C interface. Works with ID-3LA, ID-12LA and ID-20LA series systems. The selected RFID reader is simply plugged into the module\'s connectors. SparkFun SEN-15191
Module with 6-axis IMU LSM6DSO sensor, which combines a 3-axis accelerometer and gyroscope, as well as a 9kB FIFO buffer and event handling functions. Communicates via I2C or SPI. SparkFun SEN-18020
Gravity: Analog TDS Sensor / Meter is an analog water purity measurement module. It is powered by 3.3 ... 5.5V voltage and has an analogue output interface. Module compatible with Arduino. DFRobot SEN0244
I2C multiplexer module with TCA9548A system. Allows you to connect up to 8 devices. The system works like a gateway - it transmits I2C interface data to one of the 8 main busses. This allows you to connect up to 8 devices with the same address. DFRobot DFR0576
Module with a button and white LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-W
Flexible 4-core cable, 500 mm long, terminated on both sides with a Qwiic plug. Sparkfun PRT-17257
Gravity: Digital Crash sensor is a microswitch module (left) often called a limit switch. The module is powered by 5V voltage and has a digital two-state output. DFRobot SEN0138-L
Module with a precise real time clock (RTC) DS3231. It has an integrated crystal resonator and communicates via the I2C interface. Adafruit 5188
Module with integrated proximity and ambient light sensors and IR emitter in the VCNL4040 system. It allows the detection of obstacles in the range of 0 to 20 cm (no dead zone). It communicates via the I2C bus. SparkFun SEN-15177
Module with a purple LED diode. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104020002
A module with a temperature and humidity sensor based on the AHT20 system. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4566
Module with white LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030009
Pmod PIR is a module with a PIR motion sensor (EKMC1601111), which allows you to detect motion up to 5 meters from the module. The sensor during operation is characterized by low power consumption. Digilent 410-389
