A set of adapters dedicated to the XGecu T56 universal memory programmer. Enable memory support in BGA48, BGA63, TSOP56, SOP56 and EMMC153/160 package

The CY7C65213 USB to UART serial breakout is designed to provide users with a means to access all available I/O pins on the IC, and to provide a 6-pin UART header that is compatible with other SparkFun breakout boards. This breakout has a microUSB connector and other support circuitry to get the IC quickly up and running. BOB-13830

Adapter dedicated to the XGecu T56 universal memory programmer. Allows memory support in the BGA64 package

A set of adapters dedicated to the universal TL866II Plus programmer. They enable memory support in TSOP32, TSOP40 and TSOP48 package

MH-Z16 carbon dioxide sensor with Grove connector. It communicates via the UART interface. Seeed Studio 101020067

It has 10 segments, one can be highlighted in red, one in yellow, one in light green, the rest in green. This type of display can be used to indicate battery charge, liquid level in the tank, volume etc. Seeed Studio 104020006

Module with red LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030005

Module with MLX90615 temperature sensor with a measurement accuracy of 1°C and a resolution of 0.02°C. It communicates via the UART interface

Ethernet network cable UTP Cat6 unshielded patchcord, 2 m long, white, with 2xRJ45 connectors. Lanberg PCU6-10CC-0200-S

A volume sensor designed to detect loud ambient sounds. The module uses a microphone and LM2904 amplifier. The output value (analog signal) depends on the volume of the detected sound. In order to eliminate interference, the microphone signal is subjected to double filtering. Seeed studio 101020063

Module with rotary potentiometer. The connector in this module has been moved to the other side of the PCB, which makes it easier to assemble and use this module. The module has a connector in accordance with the Grove standard. Seeed studio 101020048

Module with a slide potentiometer. Depending on the position of the slider, the resistance value (maximum resistance 10kΩ) changes, which translates into the voltage value at the analog output of the module. The module has a connector in accordance with the Grove standard. Seeed studio 101020036

The module with a TA12-200 current sensor with a measuring range of alternating current up to 5 A. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020027

Resistive soil moisture sensor. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020008

Zynq-7000 All Programmable SoC, Dual ARM Cortex-A9 MPCore, Artix-7 FPGA, 28K Logic Cells, 667MHz CSPBGA400, Xilinx

The module is equipped with four 10A / 250VAC relays controlled independently via a serial bus (UART) or from a PC (through a microUSB connector). The NO / NC contacts of the relays have been led to the ARK screw terminals. ICSTATION ICSE012A

Module with an analog current sensor. Enables measurement of alternating and direct current up to 20 A. DFRobot SEN0214

The SparkFun Roshamglo is the new and fun way to play Rock-Paper-Scissors with your friends! The board uses the ATtiny84, and has an IR LED and receiver to communicate between badges. KIT-14130

Brushless DC motor (BLDC) driver with speed control by potentiometer. It can operate motors powered with a voltage from 7 to 12 V with a current consumption of up to 1.2 A