Category: Gravity peripheral modules (DFRobot)
There are 248 products.
DFRobot Gravity analog light intensity module for Arduino and Raspberry Pi. DFRobot DFR0026
A set of 10 cables, 50 cm long, compliant with the Gravity standard. DFRobot FIT0773
Laser dust sensor is a digital universal particle concentration sensor,it can be used to obtain the number of suspended particulate matter in a unit volume of air within 0.3 to 10 microns, namely the concentration of particulate matter, and output with digital interface, also can output quality data of per particle. DFRobot SEN0177
Module with barcode and QR scanner. It allows you to read one-dimensional and two-dimensional codes and communicates via the I2C and UART interface. DFRobot SEN0486
This V2 Rotation Sensor is arduino compatible multi-ring rotation sensor. It is based on multi-turn precision potentiometer. It can rotate upto 10 laps. DFR0058
Radio receiver module operating at 433 MHz. It is equipped with Gravity connectors and communicates via a digital interface. DFRobot TEL0142
A 24-channel input/output port expander module controlled by an I2C interface. It was based on the CH423 chip and equipped with a Gravity connector. DFRobot DFR0979
Module with DHT20 temperature and humidity sensor. It allows you to measure humidity in the range from 0 to 100% and temperature from -40 to 80℃. DFRobot SEN0497
DC Micro motor module with metal gear with a gear ratio of 75:1. The motor is connected to the board containing the driver. DFRobot DFR0399
DC Micro motor module with metal gear with a gear ratio of 50:1. The motor is connected to the board containing the driver. DFRobot DFR0429
Module with 5 A 250 VAC relay. DFRobot DFR0017
Module with an analog MQ8 hydrogen sensor. It is powered with the voltage of 5 V and has an analog output. DFRobot SEN0133
Module with an analog TEMT6000 light intensity sensor. The voltage at the output is linearly correlated with the intensity of the incident light. The module is supplied with the voltage from 3.3 to 5V. DFRobot SEN0043
Photoelectric liquid level sensor FS-IR02 in a set with a Gravity adapter. DFRobot SEN0205
Gravity: Digital Crash sensor is a microswitch module (left) often called a limit switch. The module is powered by 5V voltage and has a digital two-state output. DFRobot SEN0138-L
Gravity: Vibration Motor Module is a module with a small vibration motor powered by 5V voltage, controlled by a binary signal (high / low state) or using a PWM signal. DFRobot DFR0440
Radio transmitter module operating at 433 MHz. It is equipped with Gravity connectors and communicates via a digital interface. DFRobot TEL0140
Set of 10 cables, 30 cm long, for analog sensors compatible with the Gravity standard. DFRobot FIT0031
Gravity sensor adapter with 3-pin terminal connector. There are two 10 kΩ pull-up and pull down resistors on the board, set with a jumper. DFRobot DFR0055
Module with digital barometer ICP-10111. The system enables pressure measurement in the range from 300 to 1100 hPa with an accuracy of 1 Pa. DFRobot SEN0517