Best sellers
There are 15482 products.
A-Star 328P Micro is a small board based on ATmega 328PB microcontroller. The system has a loaded bootloader compatible with Arduino. The board has 24 I / O ports . The circuit board works with 5 volts logic voltage. Polol 3161
A-Star 328P Micro is a small board based on ATmega 328PB microcontroller (Flash, 32 KB, SRAM, 2.5 KB, EEPROM, 1KB, 8 MHz). The system has a loaded bootloader compatible with Arduino. The board has 24 I / O ports (of which 9 pins can be used for PWM outputs and 8 pins for analog inputs). Supply voltage 3.8-15 V. The board works with 3.3 V voltage. Pololu 3162
The IO pin expansion module is designed for minicomputers Raspberry Pi 3, Raspberry Pi 4 and Raspberry Pi 400. It contains markings of all inputs and outputs of the minicomputer. DFRobot DFR0828
A-Star 328P Micro is a small board based on ATmega 328PB microcontroller (Flash, 32 KB, SRAM, 2.5 KB, EEPROM, 1KB, 12 MHz). The system has a loaded bootloader compatible with Arduino. The board has 24 I / O ports (of which 9 pins can be used for PWM outputs and 8 pins for analog inputs). Supply voltage 3.8 ... 15 V. The board works with 3.3 V voltage. Pololu 3163
Module with a button and yellow LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-Y
I2C BME680 Environmental Sensor is a gas, pressure, temperature and humidity sensor in one MEMS housing. The module is supplied with 3.3-5V, for communication the I2C or SPI interface is used. DFRobot SEN0248
Gravity: IO Expansion & Motor Driver Shield is an Arduino compatible expansion board that provides digital I / O ports, analog I2C, SPI and UART interfaces, as well as a DC motor driver. DFRobot DFR0502
Vorel cast iron vise for fixing to the table with a clamping screw. Maximum opening 50 mm. Vorel 36005
I / O port expander designed for LattePanda V1.0. It provides all GPIO pins so that the set is compatible with the standard Arduino connector and the board does not interfere with other LattePanda ports. DFRobot DFR0491
Power strip that allows you to connect and power 3 devices using French CEE 7/5 sockets. Lanberg PS1-03E-0300-W
BMS system for five Li-Ion cells with a voltage of 21 V. It has the function of charging with balancer, discharging and over-discharge protection. The cells can be charged with continuous current up to 60 A and discharged with current up to 80 A
BMS system for four Li-Ion cells with a voltage of 16,8 V. It has the function of charging with balancer, discharging and over-discharge protection. The cells can be charged with continuous current up to 60 A and discharged with current up to 80 A
5 mm yellow LED. 1000 pieces in the package
5 mm orange LED. 1000 pieces in the package
Bluetooth 4.0 module based on the CSR8635 chip designed for Bluetooth audio applications. The module has a built-in antenna and pins for edge connectors.
3mm orange LED. 1000 pieces in the package
Module with a button and red LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-R