Best sellers
There are 15482 products.
Wireless temperature and humidity sensor. It allows you to track changes in temperature and humidity in your home. Shelly H&T BLACK
Module with environmental sensors for Raspberry Pi. It allows you to measure temperature, humidity, pressure, illuminance, detection of VOC, IR and UV radiation and orientation. Waveshare Environment Sensor HAT
A 3-port HUB module with a USB 3.2 Gen1 interface with an RJ45 connector designed to work with the Raspberry Pi minicomputer. Waveshare USB 3.2 Gen1 HUB Gigabit ETH HAT
A module with a high precision temperature sensor based on the MCP9808 chip. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 5027
Single-color LED strip driver. It allows you to control strips with LEDs powered with voltage from 12 to 24 V using built-in buttons
Gravity: Digital Crash sensor is a microswitch module (left) often called a limit switch. The module is powered by 5V voltage and has a digital two-state output. DFRobot SEN0138-L
10 cm 3-pin cable with JST PH2.0 female plug to 2.54 mm 3-pin female goldpin
Kit with 2.13" e-Paper display with passive power supply via NFC, NFC module and microSD card. Waveshare 2.13inch NFC e-Paper Eval Kit
The module (adapter) with screw connectors is dedicated to Arduino Nano boards. It facilitates the connection of external elements and prototyping
3-color (red, black, white) e-Paper display with a diagonal of 1.54" and a resolution of 200x200 px with passive power supply via NFC. Waveshare 1.54inch NFC-Powered e-Paper (BW)
Module with e-Paper display, 3.7" diagonal and 480x280 px resolution. Communication via SPI interface. Waveshare 3.7inch e-Paper HAT
The Tic T834 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using our free software. The controller supports six control interfaces: USB, TTL serial, I²C, analog voltage (potentiometer), quadrature encoder, and hobby radio control (RC).
Black PET-G ESD filament with a diameter of 1.75 mm. 0.5 kg of filament is wound on the spool. Fiberlogy PET-G ESD Black
Adapter for 20/14/10-pin JTAG. It allows to connect the JTAG programmer to a evaluation boards which uses various standards of the programming connector. IDC20, IDC14, IDC10 and JST-XH sockets are available.
At the Feather M0\'s heart is an ATSAMD21G18 ARM Cortex M0 processor, clocked at 48 MHz and at 3.3V logic, the same one used in the new Arduino Zero. This chip has a whopping 256K of FLASH (8x more than the Atmega328 or 32u4) and 32K of RAM (16x as much)! This chip comes with built in USB so it has USB-to-Serial program & debug capability built in with no need for an FTDI-like chip. Adafruit 3179
Development kit designed to support rapid prototyping and knowledge of Azure Sphere technology. Seeed Studio 102991099
Display 7 "1024x600 IPS compatible with LattePanda V1.0 mini computer. Display powered from LattePanda, no additional power supply needed DFRobot FIT0477
The expansion module is designed to work with micro:bit. It allows you to control 4 DC motors or two stepper motors and 8 servos. It communicates via the I2C interface. DFRobot DFR0548