Best sellers

Electromagnetic relay SRD-05VDC-SL-C with a coil voltage of 5 V allows controlling mains and low-voltage devices in electronic projects. Suitable for PCB boards, control modules, and automation systems.

The 10-core female-to-female connection wire with a length of 30 cm and a pitch of 2.54 mm provides reliable and flexible connections between modules and starter kits in DIY projects and prototypes

USB 2.0 hub with 10 ports and 220 V / 3.5 A external power supply. The set includes a 1 meter cable. Supports USB 2.0 standard with speeds up to 480 MBit / s. You can also connect older generation USB devices. LogiLink UA0096

The LOGO! 8 consists of a Siemens LOGO! 8, power cables and KA-LOGO! -IO-Simulator simulation board with output terminal board. Thanks to this set, it is possible to quickly and easily start learning programming of the logic module.

Pin header, 20 pin, 2,54mm

Binder organizer with SMD resistors in the 0805 housing, 15 pages of 12 lines for elements in 8mm tapes, 170 x 25 pieces,

BLOW thermal paste with a conductivity of 8.5 W/m·K in a 4 g package is a high-performance heat-conducting material, ideal for use in computers and electronic devices. It provides excellent heat dissipation efficiency, is non-conductive electrically, and does not require special application conditions. The included syringe and spatula allow for precise and clean application of the product.

The module with the four-bit logic translator TXB0104, can work in both directions. Connections using standard goldpin connectors with 2.54 mm pitch. It is compatible with BOB-11771

A module with a temperature sensor based on the absorption of infrared radiation. Enables non-contact measurement. modTMP006

The SLIM BLOW 12 V / 2 A / 24 W power supply is a compact and reliable power source for LED lighting systems. Its aluminum construction and built-in protection features against failures make it an ideal solution for home, office, and decorative installations. The small size allows for installation in hard-to-reach spaces, making it a versatile component for any LED setup.

WS2812B

LED display 14,20mm 0,56 "single, ultra-red (635nm), 40 mcd (20mA), common anode. LED1-AS-05613BMR-B PBF

Robert Górczyński

BLOW thermal paste with a conductivity of 12.5 W/m·K in a 4 g package is a high-performance heat-conducting material, ideal for use in computers and electronic devices. It provides excellent heat dissipation efficiency, is non-conductive electrically, and does not require special application conditions. The included syringe and spatula allow for precise and clean application of the product.

Tomasz Frenchman

74HC595D, 8-bit serial-in, serial or parallel-out shift register with output latches; 3-state, SO16

This RP2040-based evaluation board features an embedded W5500 Ethernet controller, providing hardware-based TCP/IP support without burdening the microcontroller. Its compact design, PoE support, and Raspberry Pi Pico-compatible interfaces make it ideal for IoT, automation, and networking projects. WIZnet W5500-EVB-Pico-POE

The GY-87 module is composed of a module with MPU6050, QMC5883L and BMP180 sensors, allowing the measurement of traffic in nine axes and the measurement of atmospheric pressure. The module has a built-in 3.3 V voltage stabilizer

The unshielded self-locking RJ-45 connector Category 6A is designed for network installations using twisted-pair cables in environments with minimal electromagnetic interference. Its easy tool-free installation, compatibility with a wide range of cable diameters, and reusability make it a practical choice for LAN projects in offices, homes, and other locations with moderate transmission loads.

SEQURE HT140 is an advanced 2-in-1 hot tweezers soldering iron, offering flexibility, fast heating, and wide compatibility with modern power supplies. With interchangeable tips, intelligent temperature control, and a compact design, it is suitable for both electronics repair and professional service environments where precision and reliability are essential.