Best sellers
There are 16521 products.
YATO YT-81500 19mm cable harness tape. The tape is intended for organizing and securing electric cable bundles.
JST SH type connector, 1.0 mm pitch, surface mounted, vertical spatial orientation. The set includes 10 connectors
HC-08 is a module operating in the Bluetooth Low Energy 4.0 standard. The system has a built-in antenna and small dimensions, and thanks to edge joints it can be surface soldered. The module is configured via AT commands
Straight dowel strip with a pitch of 2.54 mm in a 1x3 arrangement. The set contains 10 pieces
12-wire cable, 10 cm long, with a JST SH-1.0 female plug at one end
Neodymium rectangular magnet with dimensions of 30x10mm a and a height of 3 mm.
6-wire cable, 30 cm long, with a JST PH-2.0 female plug at one end
IC socket in DIP24W package, 24-pin, 2.54 mm pitch, 15.24 mm pitch, RoHS
Double-sided printed circuit board, SOT89/SOT223 to DIP adapter.
A module with a 3-axis accelerometer that allows you to measure acceleration in the range of ± 16g with a resolution of 13 bits. GY-291 ADXL345
Soldering paste medium-active flux with the consistency of a paste based on rosin and organic halogen activator, facilitating the soldering of copper, silver, zinc and nickel elements. AG Termopasty ART.AGT-037
Permanent cylindrical neodymium magnet with a diameter of 6 mm and a height of 5 mm. Set of 10 pcs
Practical solution for converting DC connectors in electronics projects, enabling safe and stable power connections. ADP0023
Development kit with STM32L496ZGT6 microcontroller with built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone.
The compact RJ45 LAN splitter allows you to easily connect two devices to one network socket with the possibility of alternating operation. Lanberg AD-RJ45-2RJ45-OU
The KAmod BlackPill 411 is an evaluation board featuring the STM32F411CEU microcontroller, offering versatile programming capabilities with a USB-C connector and a pre-installed bootloader compatible with Arduino IDE. Equipped with 32 GPIOs, a modified power circuit, and ESD protection, it is perfect for embedded projects.
The KAmod ESP32-C3 board, equipped with a RISC-V microcontroller and a set of MEMS and SHTC3 sensors, enables the creation of IoT, measurement, and control applications. Thanks to power from USB-C or a battery and support for Arduino and Rust, it works perfectly in mobile projects and embedded systems.
Adapter from female BNC connector to terminal spring connector