Best sellers
There are 16521 products.
Compact stepper motor controller with the TMC2130 system with operating voltage from 5.5 to 45 V. It offers smooth, quiet operation, high efficiency, various operating modes and easy configuration. It is controlled via the STEP/DIR interface and is an ideal solution for 3D printers and similar applications. BIGTREETECH TMC2130 V3.0
Neodymium rectangular magnet with dimensions of 30x10mm a and a height of 3 mm.
IC socket in DIP24W package, 24-pin, 2.54 mm pitch, 15.24 mm pitch, RoHS
6-wire cable, 30 cm long, with a JST PH-2.0 female plug at one end
The KAmod ESP32-C3 board, equipped with a RISC-V microcontroller and a set of MEMS and SHTC3 sensors, enables the creation of IoT, measurement, and control applications. Thanks to power from USB-C or a battery and support for Arduino and Rust, it works perfectly in mobile projects and embedded systems.
Electronic components tester with a 128x64 pixel display. It allows you to check, among others transistors, diodes, capacitors, resistors and inductors. Acrylic housing included. LCR-T4
The Xtreme 12V 4Ah AGM battery is a reliable, maintenance-free power solution for motorbikes and backup systems, offering long life, leak-proof design, and universal application versatility.
JST SH type connector, 1.0 mm pitch, surface mounted, vertical spatial orientation. The set includes 10 connectors
Switched-mode AC Power supply 12V/2A with DC 5.5x2.1 connector and EU plug. It has anti-overload, anti-overvoltage, short circuit protection. Conform to the norm Energy efficiency Level V. Length of output cable is 1.2m
A module with a 3-axis accelerometer that allows you to measure acceleration in the range of ± 16g with a resolution of 13 bits. GY-291 ADXL345
12-wire cable, 10 cm long, with a JST SH-1.0 female plug at one end
Permanent cylindrical neodymium magnet with a diameter of 6 mm and a height of 5 mm. Set of 10 pcs
Female terminal block, 3-pin. Pitch 3.5mm. Height 7.8mm. Suitable for KF2EDGR male strips with a pitch of 3.5 mm. 2EDGKN-3.5
Development kit with STM32L496ZGT6 microcontroller with built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone.
Straight dowel strip with a pitch of 2.54 mm in a 1x3 arrangement. The set contains 10 pieces
YATO YT-81500 19mm cable harness tape. The tape is intended for organizing and securing electric cable bundles.
HC-08 is a module operating in the Bluetooth Low Energy 4.0 standard. The system has a built-in antenna and small dimensions, and thanks to edge joints it can be surface soldered. The module is configured via AT commands
The compact RJ45 LAN splitter allows you to easily connect two devices to one network socket with the possibility of alternating operation. Lanberg AD-RJ45-2RJ45-OU
The NRF24L01+ chip module for radio communication, which operates in the 2.4 GHz ISM band. It is used in various applications such as wireless sensors, remote control, wireless networks. It supports the Enhanced ShockBurst protocol, which provides automatic packet handling. It communicates via an SPI interface
Practical solution for converting DC connectors in electronics projects, enabling safe and stable power connections. ADP0023