Best sellers

A data logging module dedicated to the Raspberry Pi Pico. It features an RTC clock, Micro SD slot and STEMMA QT connector. Adafruit 5703

Espressif ESP32-S3 WiFi and BLE chip module with 1.14" TFT LCD display. It integrates a LiPo charging circuit and an RGB diode. It is equipped with a STEMMA QT connector. Adafruit 5691

RC extension cable dedicated to servos, comes with JR/Futaba female and male connectors. It has twisted wires

RC extension cable dedicated to servos, comes with JR/Futaba female and male connectors. It has twisted wires

RC extension cable dedicated to servos, comes with JR/Futaba female and male connectors. It has twisted wires

STM32H753VIT6, 32-bit microcontroller, Arm Cortex-M7 with 2 MB Flash, 1 MB RAM, 480 MHz, DSP with DP-FPU, HW Crypto, LQFP100

HDMI-USB adapter dedicated to video capture and transfer to devices with a USB Type A connector. It supports resolutions up to 4K with a refresh rate of 30 Hz. Waveshare HDMI to USB3.0 Adapter

BMA400 3-axis accelerometer module with a measurement range of up to ±16g. The board is equipped with a Qwiic connector and communicates via an I2C or SPI interface. SparkFun SEN-21208

Module with Flash memory W25Q64 with a capacity of 64 Mbit (8 MB). It communicates via the SPI interface. Adafruit 5636

RC extension cable dedicated to servos, comes with JR/Futaba female and male connectors. It has twisted wires

A universal programmer compatible with safety test cables from the O.MG Cable, O.MG Plug, O.MG Adapter and O.MG UnBlocker series. O.MG Cable: USB A+C Programmer

TDA7297 stereo audio digital amplifier module. The system allows you to connect two speakers with an impedance from 4 to 8 Ω and a power of 15 W

LM386 mono digital audio amplifier module. It has a voltage gain of 200 and is powered from 5V to 12V

Hermetic casing ZP90.60.40 light bottom with ears - colorless top with a flooded gasket and brass PC sleeves

Stereo audio amplifier based on the TDA7498 chip. It can be powered with the voltage from 20 to 36 V and has two 100 W outputs

PAM8610 digital stereo audio amplifier module. The system allows you to connect two speakers with an impedance from 4 to 8 Ω and a power of 10 W

Stereo audio amplifier with Bluetooth 4.0 communication. It can be powered with 12 V and has two 25 W outputs

IC socket in DIP20 package, 20-pin, 2.54 mm pitch, 7.62 mm pitch, RoHS