Best sellers
There are 16455 products.
ARK terminal connector spring 8-pin, pitch 3.81 mm, non-detachable
Neodymium rectangular magnet with dimensions of 30x10mm a and a height of 3 mm.
12-wire cable, 10 cm long, with a JST SH-1.0 female plug at one end
JST SH type connector, 1.0 mm pitch, surface mounted, vertical spatial orientation. The set includes 10 connectors
The NRF24L01+ chip module for radio communication, which operates in the 2.4 GHz ISM band. It is used in various applications such as wireless sensors, remote control, wireless networks. It supports the Enhanced ShockBurst protocol, which provides automatic packet handling. It communicates via an SPI interface
FPC/FFC 24-pin adapter with 0.5mm pitch for DIP holes 2.54mm pitch.
Needle bending needle, for precise glue application, Flux 0.413mm internal diameter and 0,7176mm outside diameter. Set of 5 pcs
Unshielded UTP category 5E Ethernet network cable with RJ45 plugs. Lanberg PCU5-10CC-0050-B
Female terminal block, 3-pin. Pitch 3.5mm. Height 7.8mm. Suitable for KF2EDGR male strips with a pitch of 3.5 mm. 2EDGKN-3.5
Waterproof connector with plug, gaskets and contacts included. It can work with a voltage of up to 300 V and a current of up to 12 A
Adapter from female BNC connector to terminal spring connector
Straight dowel strip with a pitch of 2.54 mm in a 1x3 arrangement. The set contains 10 pieces
The MS-1A-WB-L limit switch with dimensions of 12 x 6 x 6 mm is designed to operate at a current of 1A and a voltage of 125V. The set includes 5 pieces and the operating temperature range is from -25°C to 65°C
The compact RJ45 LAN splitter allows you to easily connect two devices to one network socket with the possibility of alternating operation. Lanberg AD-RJ45-2RJ45-OU
A set consisting of the most commonly used goldpin connectors
Electronic components tester with a 128x64 pixel display. It allows you to check, among others transistors, diodes, capacitors, resistors and inductors. Acrylic housing included. LCR-T4
Compact stepper motor controller with the TMC2130 system with operating voltage from 5.5 to 45 V. It offers smooth, quiet operation, high efficiency, various operating modes and easy configuration. It is controlled via the STEP/DIR interface and is an ideal solution for 3D printers and similar applications. BIGTREETECH TMC2130 V3.0
The MQ-5 sensor allows the measurement of alcohol and gas concentrations, such as methane, LPG, and carbon monoxide. Sensor measuring range: up to 10,000 ppm
Development kit with STM32L496ZGT6 microcontroller with built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone.
The KAmod BlackPill 411 is an evaluation board featuring the STM32F411CEU microcontroller, offering versatile programming capabilities with a USB-C connector and a pre-installed bootloader compatible with Arduino IDE. Equipped with 32 GPIOs, a modified power circuit, and ESD protection, it is perfect for embedded projects.