Maxbotix LV-MaxSonar-EZ4 - ultrasonic distance sensor MB1040 (645cm)

Ultrasonic distance sensor with a range of up to 5 m with an analog output The module is supplied with the voltage from 3.3 to 5.5 V. DFRobot SEN0307

Laser distance sensor with a measuring range of up to 2 m, based on the ToF measurement technique. Communication with the module takes place via the I2C interface. Waveshare VL53L0X Distance Sensor

Ultrasonic ToF sensor dedicated to the identification of materials at a distance of 2 to 10 cm. It can distinguish between hard and soft materials and transmits information via digital IO (high/low) or UART interface. DFRobot SEN0560

Laser scanner (Lidar) 360 degrees with a measurement frequency of 10 Hz and 8000 measurements / second. It reaches a range of up to 12 m and a measurement error of 1%. Sparkfun SEN14756

ToF distance sensor module based on the VL6180X system. It offers a range of 2 to 50 cm and communicates via the I2C interface

Ultrasonic distance sensor MB1000 with a range from 0 to 645 cm. It has an output in the form of a serial interface, an analog signal or generates an impulse whose duration is proportional to the measured distance. Pololu 723

Module with integrated proximity and ambient light sensors and IR emitter in the VCNL4040 system. It allows the detection of obstacles in the range of 0 to 20 cm (no dead zone). It communicates via the I2C bus. SparkFun SEN-15177

Pololu Carrier with Sharp GP2Y0D810Z0F Digital Distance Sensor 10cm

Ultrasonic distance sensor with a range from 3 to 350 cm. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 101020010

LiDAR sensor using distance measurement technology based on the principle of triangulation. It offers a measurement range from 25 to 300 mm and a measurement frequency of 28 Hz, thanks to which it ensures fast and effective data acquisition in various environmental conditions. DFRobot DFR1030

Ultrasonic distance sensor (sonar) with a measuring range from 50 cm to 10 m. It allows you to read data through one of three interfaces: variable width pulse, analog output or UART TTL interface. DFRobot SEN0277

Module with an obstacle sensor operating in the infrared band. Equipped with an XH2.54 connector, it has a digital output informing about the detection of an obstacle

ToF distance sensor (Time of flight) with a range of up to 5 m. The module is supplied with the voltage of 3.3 V and communicates via the I2C interface. SparkFun SEN-19218

Module with a digital distance sensor with a range of up to 5 cm. It has a digital output that goes low when an object is detected. Pololu 4050

The GP2Y0A60SZ distance sensor from Sharp offers a wide detection range of 4″ to 60″ (10 cm to 150 cm) and a high update rate of 60 Hz. The distance is indicated by an analog voltage, so only a single analog input is required to interface with the module.

Ultrasonic distance sensor with a measuring range of 2 to 400 cm. Communicates via a standard interface (Echo, Trigger) or I2C bus. SparkFun SEN-24805