

zł59.32 tax excl.
This sensor is a carrier/breakout board for ST’s VL6180X proximity and ambient light sensor, which measures the range to a target object up to 20 cm away (or 60 cm with reduced resolution). Pololu 2489
The distance and light intensity sensor module based on the VL6180X system is equipped with a voltage stabilizer and logic level converters. The sensor uses Time of Flight (ToF) technology to obtain accurate results regardless of the surface and color of the object being detected.
The default range of the sensor is 1-20 cm, to get a measurement resolution of 1 mm, set the range to 10 cm. The maximum possible distance to be measured with reduced resolution is 60 cm.
The measurement results can be read via the I2C interface with a maximum speed of 400 kHz (Fast Mode). The sensor operates at a voltage of 2.7 V but thanks to the stabilizer and logic level converters the module can operate at a voltage in the range of 2.7-5.5 V.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Set of 40 pieces of male-female connection cables, in various colors, 17 cm long. CAB_M-F (Rainbow-40-17)
A set of 40 female-female connection cables, in various colors, 17 cm long. CAB_F-F (Rainbow-40-17)
KAmodVL6180X is a module that allows to measure light intensity (ALS), distance to the object and recognition of gesture. It has an embedded voltage regulator and voltage level translators on signal lines. Thanks to this can be used in systems with 2.8...5.5V power supply voltage.
This sensor is a carrier/breakout board for ST’s VL53L0X laser-ranging sensor, which measures the range to a target object up to 2 m away.
VL53L0X ToF Laser Range Finder is a laser distance sensor using the ToF (Time of Flight) measurement technique. The module is supplied with 3.3 ... 5 V voltage and can measure up to 2 m. DFRobot SEN0245
No product available!
Distance sensor module operating in TOF technology, operating range 4-400 cm, resolution up to 1 mm. Communication with the sensor via the I2C bus. Power supply through a built-in regulator with voltage from 2.6 to 5.5 V. Pololu 3415
ToF distance sensor module based on the VL6180X system. It offers a range of up to 10 cm and communicates via the I2C interface. Adafruit 3316
Module with a distance sensor with a range of up to 130 cm. It has a digital output that generates a pulse with a width proportional to the measured length. Pololu 4071
ToF distance sensor module based on the VL6180X system. It offers a range of 2 to 50 cm and communicates via the I2C, UART or Modbus interface. TOF050F
No product available!
Ultrasonic obstacle sensor (vehicles) with high resolution and range up to 500cm with USB interface. It allows you to perform measurements at 4Hz. DFRobot SEN0268
No product available!
Distance measurement tester designed for HC-SR04 ultrasonic sensor. It is equipped with a 3-digit 7-segment LED display showing the current measurement and a measurement processing system with UART output
ToF distance sensor (Time of flight) with a range of up to 2.5 m. The module is powered with the voltage of 3.3 V and communicates via the I2C interface. DFRobot SEN0430
Module with an obstacle sensor operating in the infrared band. Equipped with an XH2.54 connector, it has a digital output informing about the detection of an obstacle
Time-of-Flight VL53L3CX Distance Sensor Expansion Board. The set is designed to measure distances and detect gestures. Distance measurement was carried out using VL53L3CX laser sensors. STMicroelectronics X-NUCLEO-53L3A2
Module with ultrasonic distance sensor HC-SR04 with a range of up to 400 cm. It communicates via the I2C interface. SparkFun SEN-15171
No product available!
Module with a digital distance sensor with a range of up to 5 cm. It has a digital output that goes low when an object is detected. Pololu 4050
No product available!
LIDAR-Lite v3HP is a laser rangefinder with a measuring range of 5 cm ... 40 m. Power consumption is a maximum of 85 mA. Supply voltage in the range 4.75 ... 5 V. Class 1 laser. I2C or PWM interface. SparkFun SEN-14599
No product available!
IR proximity sensor used to detect objects at a distance of 10mm to 80mm using infrared radiation. It is powered by 5 V and has a digital output. DFRobot SEN0556
No product available!
A module with a distance sensor GP2Y0E03 operating in the infrared band. The sensor measures between 4-50cm.
Pololu Carrier for Sharp GP2Y0D810Z0F and GP2Y0D805Z0F Sensors
This sensor is a carrier/breakout board for ST’s VL6180X proximity and ambient light sensor, which measures the range to a target object up to 20 cm away (or 60 cm with reduced resolution). Pololu 2489