zł53.00 tax excl.
VL53L0X ToF Laser Range Finder is a laser distance sensor using the ToF (Time of Flight) measurement technique. The module is supplied with 3.3 ... 5 V voltage and can measure up to 2 m. DFRobot SEN0245
The VL53L0X ToF Laser Range Finder is a laser distance sensor based on the ToF (Time of Flight) technique. The ToF method consists in measuring the time from emitting a pulse from the infrared laser to its return to the detector. Thanks to this technique, the VL53L0X sensor enables accurate measurements regardless of the color or reflection of the light from the object. The module has a range of up to 2 m with an accuracy of 3%. It can be supplied with voltage in the range of 3.3 ... 5 V. Communication with the sensor takes place via the I2C interface. Robotics or devices requiring precise measurements can be used. The sensor can detect simple hand gestures.
The product is compatible with Arduino boards and has a library prepared for Arduino IDE.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Arduino Uno Rev3 is a popular board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface. Arduino A000066
No product available!
Expansion board for Arduino, allows easy connection of XBee modules, has separate outputs for I2C, SPI and UART buses. The built-in 3.3V voltage stabilizer and operating mode switch make it easier to program the Arduino when the XBee module is connected to the sockets. DFRobot DFR0265
The X-NUCLEO-53L0A1 expansion board features the VL53L0X ranging and gesture detection sensor, based on ST’s FlightSense™, Time-of-Flight technology. It is an evaluation board that provides an introduction to the ranging and gesture detection capabilities of the VL53L0X module
No product available!
This sensor is a carrier/breakout board for ST’s VL53L0X laser-ranging sensor, which measures the range to a target object up to 2 m away.
Integrated circuit - a distance sensor based on the technique of measuring the time between transmitting a light wave and returning its reflection (so-called Time of Flight - ToF). The system transmits data via the I2C bus and can measure distances up to 2 meters. The system has a small size and fits in the Optical LGA12 housing
No product available!
Pololu Carrier with Sharp GP2Y0D810Z0F Digital Distance Sensor 10cm
Module with a digital distance sensor with a range of up to 5 cm. It has a digital output that goes low when an object is detected. Pololu 4050
The GP2Y0A60SZ offers a wide detection range of 4″ to 60″ (10cm to 150cm) and a high update rate of 60Hz. The distance is indicated by analog voltage - only a single analog input is required to interface with the module. Pololu 2476
Time-of-Flight VL53L3CX Distance Sensor Expansion Board. The set is designed to measure distances and detect gestures. Distance measurement was carried out using VL53L3CX laser sensors. STMicroelectronics X-NUCLEO-53L3A2
Ultrasonic distance sensor (sonar) with a measuring range from 50 cm to 10 m. It allows you to read data through one of three interfaces: variable width pulse, analog output or UART TTL interface. DFRobot SEN0271
No product available!
IR proximity sensor used to detect objects at a distance of 10mm to 80mm using infrared radiation. It is powered by 5 V and has a digital output. DFRobot SEN0556
Module with an obstacle sensor operating in the infrared band. Equipped with an XH2.54 connector, it has a digital output informing about the detection of an obstacle
Module with a digital distance sensor with a range of up to 50 cm. It has a digital output that goes low when an object is detected. Pololu 4067
Ultrasonic distance sensor with a range of up to 15m. Powered with the voltage from 9 to 24 V, it communicates via the RS485 interface. DFRobot SEN0310
No product available!
LiDAR CS20 3D TOF equipped with a ToF image sensor with a resolution of 640 x 480 pixels. It uses ToF technology to record three-dimensional information about objects and space. It can accurately measure distances up to 5 m. DFRobot SEN0579
No product available!
Laser sensor module with a range of up to 50 m and an accuracy of 1 mm. Communication with the module takes place via the UART interface.
Module with ToF VL53L4CD sensor with a range of up to 1.3 m and a resolution of 1 mm. It is equipped with a STEMMA QT connector and communicates via the I2C interface. Adafruit 5396
Optical Time of Flight sensor with Pmod I2C connector. The built-in ISL29501 digital signal processor calculates the time it takes for the light emitted by ToF to reach the destination and back. The calculated time is proportional to the distance. Pmod ToF has a range of up to 5 m. Digilent 410-392
ToF distance sensor module with a range of 5 to 180 cm. Communication via UART or I2C.
KAmodVL6180X is a module that allows to measure light intensity (ALS), distance to the object and recognition of gesture. It has an embedded voltage regulator and voltage level translators on signal lines. Thanks to this can be used in systems with 2.8...5.5V power supply voltage.
VL53L0X ToF Laser Range Finder is a laser distance sensor using the ToF (Time of Flight) measurement technique. The module is supplied with 3.3 ... 5 V voltage and can measure up to 2 m. DFRobot SEN0245