Qwiic Servo pHAT - shield with a servo driver for Raspberry Pi

This add-on board enables a Raspberry Pi B+, Pi A+, Pi 2 or Pi 3 to drive a pair of brushed DC motors. Its dual MC33926 motor drivers operate from 5 V to 28 V and can deliver a continuous 3 A (5 A peak) per motor. The default pin mappings make it easy to get started using our provided software, but the board also exposes most of the driver chips’ I/O pins for more specialized applications. 

DC motor controller that allows the movement of three drives to be controlled via an I2C interface. Kit with connectors for self-assembly. Pololu 5072

Adafruit 16-Channel PWM / Servo HAT for Raspberry Pi - Mini Kit (Adafruit 2327)

DC motor driver that allows you to control the movement of three drives using the I2C interface. Pololu 5035

Extension module with a driver for two stepper motors based on the HR8825 system. Dedicated for Raspberry Pi minicomputers. Waveshare Stepper Motor HAT (B)

The PCA9685 servo driver module is dedicated to Raspberry Pi minicomputers. It allows you to control 16 PWM channels. SB Components 08957

HAT with two-channel DC motor driver for Raspberry Pi. It has an operating voltage from 6 to 24 V and a continuous current of up to 10 A. It can be controlled by a PWM signal or by means of built-in buttons. Cytron HAT-MDD10

This add-on board makes it easy to control two high-power DC motors with a Raspberry Pi. Its twin discrete MOSFET H-bridges support a wide 6.5 V to 36 Voperating range and are efficient enough to deliver a continuous 14 A without a heat sink. The drivers offer basic current limiting functionality, and they accept ultrasonic PWM frequencies for quieter operation.

PCA9685 servo controller module dedicated to Raspberry Pi minicomputers. Allows control of 16 PWM channels. Waveshare Servo Driver HAT (B)

DC motor driver that allows you to control the movement of two drives using the I2C interface. Board with soldered connectors. Pololu 5048

This compact expansion board plugs directly into the GPIO header on a Raspberry Pi B+, A+, or Pi 2 and provides an easy and low-cost solution for driving a pair of small brushed DC motors. Pololu 2753

DC motor driver that allows you to control the movement of two drives using the I2C interface. Board with connectors for assembly. Pololu 5055

Extension module with a driver for two stepper motors based on the DRV8825 system. Dedicated for Raspberry Pi minicomputers. Waveshare Stepper Motor HAT

Module with a 2-channel driver for DC motors TB6612FNG designed to work with the Raspberry Pi. It can work with voltages from 6 to 12 V and currents up to 3 A. SB Components 21468

DC motor driver that allows you to control the movement of two drives using the I2C interface. Board without connectors. Pololu 5050

Raspberry Pi Expansion Board, DC Motor / Stepper Motor Driver