Gravity: Terminal Sensor Adapter V2.0 - Gravity adapter with terminal connector

Radio transmitter module operating at 433 MHz. It is equipped with Gravity connectors and communicates via a digital interface. DFRobot TEL0140

Module with a miniature DC motor. No additional controller is required to start the engine. The module is controlled by the PWM signal. DFRobot DFR0411

A small WiFi module designed for IoT applications. It can communicate with the motherboard via the I2C or UART interface. DFRobot TEL126

Module with an analog TEMT6000 light intensity sensor. The voltage at the output is linearly correlated with the intensity of the incident light. The module is supplied with the voltage from 3.3 to 5V. DFRobot SEN0043

Module with green LED, digitally controlled. Perfect for people starting to play with Arduino. Equipped with a Gravity interface. DFRobot DFR0031-G

Gravity: Heart Rate Monitor Sensor is a sensor used to measure heart activity. Adapted for easy use with Arduino. SparkFun SEN0213

The analog pH meter, specially designed for Arduino controllers, with the connector (Gravity series). It has an LED which works as the Power Indicator, a BNC connector and PH2.0 sensor interface. The pH measurements at ± 0.1pH (25?). SEN0161

Gravity: Digital IR Receiver Module is a module with an IR receiver operating at 38kHz. The module is supplied with 5V voltage. DFRobot DFR0094

DFRobot 315MHz RF receiver module using SC2272-L4 low power decoder chip. DFRobot TEL0112

Module with an analog AC current sensor in a set with a probe for non-contact measurement of alternating current with a current of up to 10 A. DFRobot SEN0288

Waterproof soil moisture sensor with analog output. The probe has a pointed tip, which allows it to be easily inserted into the ground. It is supplied with the voltage from 3.3V to 5.5V. DFRobot SEN0308

Module with a digital temperature and humidity sensor based on the SHT31-F system. Communication via the I2C interface. Equipped with a Gravity DFRobot SEN0334 connector

Module with red LED, digitally controlled. Perfect for people starting to play with Arduino. Equipped with a Gravity interface. DFRobot DFR0021-R

Gravity: Voice Recorder Module is a sound recording module powered by 5V voltage. It can store sounds up to 10 seconds long. DFRobot SEN0197

I2C multiplexer module with TCA9548A system. Allows you to connect up to 8 devices. The system works like a gateway - it transmits I2C interface data to one of the 8 main busses. This allows you to connect up to 8 devices with the same address. DFRobot DFR0576

Gravity: Analog Sound Sensor is a sound sensor with Gravity analogue output. The module can be supplied with 3.3 ... 5V voltage. DFRobot DFR0034