DFRobot- Power Shield (Arduino Compatible)

A module with a microSD card slot for Arduino. Equipped with two Grove connectors with I2C and UART for connecting additional sensors. Seeed Studio 103030005

The Beetle shield is designed to attach a Beetle controller for easy connecting servos and sensors. DFR0285

The expansion module (shield) is designed for Arduino boards. It enables easy connection of 16x32 and 32x32 matrix displays. Requires self-assembly. Adafruit 2601

Shield dedicated to Arduino boards, which allows you to program AVR systems. Equipped with ISP connectors (6-pin and 10-pin) and a ZIF-28 base. AVR ISP Shield

The X-NUCLEO-53L0A1 expansion board features the VL53L0X ranging and gesture detection sensor, based on ST’s FlightSense™, Time-of-Flight technology. It is an evaluation board that provides an introduction to the ranging and gesture detection capabilities of the VL53L0X module

Gravity: Heart Rate Monitor Sensor is a sensor used to measure heart activity. Adapted for easy use with Arduino. SparkFun SEN0213

The module with 4 relays is designed to work with Arduino. It allows you to control devices with operating parameters up to 250VAC/7A or 30VDC/10A. Seeed Studio 103030009

Arduino Shield - MEGA Proto KIT Rev3

e-Paper display controller module with a standard Arduino connector. It has a built-in MX25R6435F Flash memory with a capacity of 8 MB and a 24-pin FFC connector dedicated to e-Paper displays. Waveshare e-Paper Shield (B)

Extension module (shield) with a signal generator for Arduino Pro Mini. It can trigger a sine, square or triangle waveform up to 3MHz. SparkFun BOB-11420

Arduino Wireless Shield

Base Shield V2 is an extension for tiles with an Arduino shield connector, it has a Grove connector, which can be connected to Grove-compatible modules / sensors. Seeedstudio 103030000

WiFiBee-MT7681 is an XBee module based on the MT7681 Wi-Fi module. WiFiBee supports standard IEEE802.11b / g / ni protocols. Can be used as a remote programmer for Arduino tiles. It is powered by 3.3 V. DFRobot TEL0107

Shield for Arduino containing the most commonly used peripherals in an easy-to-use form. It is equipped with: OLED display, RGB diode, buttons, temperature and humidity sensor and joystick. DFRobot DFR0270

The shield allows for easier connection of cables to the Arduino UNO R3 board. Thanks to the screw connectors, it is possible to fast and secure the cable, goldpin connectors allow you to easily connect the servo, and the built-in female connectors allow you to put additional Arduino shields

Expansion module with a joystick and buttons, resembling a gamepad. Enables the connection of the nRF24L01 radio module, Nokia 5110 display, Bluetooth module, I2C devices and Arduino kit. modKeyPad