- Out-of-Stock
The cable is designed for connections at distribution points and subscriber outlet connections to active devices such as a switch, router or directly to the computer's network card. Patchcords are used in connections of passive and active devices in LAN, Ethernet, xDSL and telephone networks - at home, office and industry. Made in accordance with the applicable standards, subjected to repeated tests and verification ensure the highest transmission parameters and compliance with the given category.
They meet the following product and application standards: PN-EN 41003: 2001, PN-EN 50173: 2004, ISO / IEC 11801: 2002, ANSI / TIA / EIA-568-B.2-1, PN-EN 60-603-7 -1: 2002 (U).
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Tester for testing cables with RJ45 and RJ11 plugs. Detects abnormalities such as short circuits, openings, reversed wires, swapped pairs. NAR0167
Crimping tool for 8P8C (RJ-45), 6P6C (RJ-12), 6P4C (RJ-11), 6P2C plugs with a clipper. NAR0008
Connector pliers for 8-pin, 6-pin, 4-pin connectors, incl. 8P8C (RJ-45), 6P6C (RJ-12), 6P4C (RJ-11), 4P4C, 4P2C PLUGS, DEC / OFF SET PLUG-6P6C, equipped with 2 knives. NAR0051
No product available!
Wireless motion sensor and magnetic field with built-in event memory (recorder)
No product available!
Wireless, accurate temperature and humidity sensor with built-in event memory (recorder)
No product available!
Wireless, accurate temperature and humidity sensor with built-in event memory (recorder)
No product available!
Connection of 5MPx camera with JPEG compression with full BLE functionality
No product available!
The device allows the presence of devices with BLE in networks with Ethernet protocol, extends the range of sensors iNode Care Sensor
No product available!
A wireless energy consumption monitor with built-in memory, thanks to the analysis of daily consumption, can help reduce the cost of electricity consumption
No product available!
A wireless energy consumption monitor with built-in memory, thanks to the analysis of daily consumption, can help reduce the cost of water consumption
No product available!
Flex Cable for Raspberry Pi Camera - 200mm / 8". Adafruit 1647
No product available!
MYIR MYC-C7Z010 is a single board module based on the MYC-C7Z010 chip. This system consists of a dual-core processor based on the Cortex-A9 core (667 MHz) and the Artix-7 FPGA chip. The board has 1 GB of DDR3 SDRAM, 4 GB of eMMC memory and 32 MB of QSPI Flash memory. The board is equipped with numerous peripherals, the outputs of which have been led out on two 140-pin connectors.
No product available!
No product available!
AVT kit for self-assembling LEDs, contains a set of elements. AVT1844 B
No product available!
Assembled AVT set, Christmas, shining Christmas tree LED. AVT1844 C
No product available!
The sensor detects dangerous carbon monoxide and carbon monoxide, signals a gas leak and the presence of carbon monoxide in rooms. URZ0409
No product available!
Female-female 10-core connection cable, 15 cm long with connectors of 1.27 mm pitch. Adafruit 1675
No product available!
32GB microSDHC Memory Card with SD Adapter, class 4, Kingston
No product available!
Development kit chipKIT DP32 equipped with PIC32MX250F128B microcontroller (40/50 Mhz, 128 kB Flash, 32 kB RAM), prototype area with solder pads, potentiometer, 4 LED diodes, 2 buttons and soldering pads for EEPROM memory and analog temperature sensor. Digilent 410-280P-KIT
No product available!
Patchcord UTP 5E Ethernet cable with a length of 50 cm - gray, with 2xRJ45 connectors