P-NUCLEO-IOM01M1 - STM32 Nucleo pack for IO-Link master with IO-Link v1.1 PHY and stack

 Description

The P-NUCLEO-IOM01M1 is an STM32 Nucleo pack composed of the STEVAL-IOM001V1 and the NUCLEO-F446RE board. The STEVAL-IOM001V1 is a single IO-Link master PHY layer (L6360) while the NUCLEO- F446RE runs an IO-Link stack rev 1.1 (developed by and property of TEConcept GmbH, license limited to 10k minutes, renewable without additional costs).

The STM32 Nucleo pack provides an affordable and easy-to-use solution for the evaluation of IO-Link applications, L6360 communication features and robustness, together with the STM32F446RET6 computation performance. The pack, hosting up to four STEVAL-IOM001V1 to build a quad port IO-Link master, can access the IO-Link physical layer and communicate with IO-Link Devices.

You can evaluate the tool via the dedicated GUI (IO-Link Control Tool^©, propriety of TEConcept GmbH) or use it as an IO-Link master bridge accessible from the dedicated SPI interface: source code of demo project (Low-Level IO-Link Master Access, developed by TEConcept GmbH) is available for free.

 Features

• STEVAL-IOM001V1
  • IO-Link master PHY based on L6360
  • Interrupt diagnostics pin
  • I²C and UART interface
  • SPI (slave) interface
  • 65 mA selectable (3.3 or 5.0 V) linear regulator
  • CQ (push-pull) and L+ (high side) switches
  • IQ additional IEC61131-2 type 1 digital input
  • L+ and CQ overload and overheating protections with non-dissipative cut-off function
  • QFN-26L (3.5x5x1 mm) package
  • Operating voltage range from 18 to 32.5 V
  • Additional high side switch for L+ heavy loads (IPS161H)
  • LEDs for status and diagnostics
  • Ground and V_CC wire break protections
  • EMC compliance with IEC61000-4-2, IEC61000-4-3, IEC61000-4-5
  • Equipped with ST morpho connectors
  • CE certified
  • RoHS and China RoHS compliant
• NUCLEO-F446RE
  • STM32F446RET6 32-bit Micro-controller based on ARM^®Cortex^®-M4 core (180 MHz max.) with 512-Kbyte Flash memory and 128 (+4) Kbyte RAM
  • Two types of extension resources: Arduino™ UNO Revision 3 connectivity and ST morpho extension pin headers for full access to all STM32 I/Os
  • Mbed-enabled (http://mbed.org)
  • On-board ST-LINK/V2-1 debugger/programmer with SWD connector: selection-mode switch to use the kit as a standalone ST-LINK/V2-1
  • Two push-buttons: USER and RESET