- Out-of-Stock
AVT5638 B - a miniature reminder. Self-assembly set
ID: 572368
AVT kit for self-assembly of a miniature reminder. AVT5638 B
Description
This small device has been designed, above all, for diabetic care, but you can find a much wider range of applications for it. Its task is to signal the passage of a previously set time interval, measured from pressing a button. In this way, it is possible to remind about the need to measure the level of glucose in the blood after some time from the meal, or to look into the boiler room after some time from firing in the oven.
Project AVT 5638 EP 08/18
properties
- Power from a 3V lithium battery
- Power consumption: in standby mode 0.5 mA, in the active state 8 mA, in the alarm state 7 mA
- Measuring one of 4 predefined times: 15 minutes, 30 minutes, 1 hour, 2 hours
- Timing triggered by the button
- Time set by the DIP-SWITCH switch
- ATtiny12A microcontroller, software in C language
Included
- Assembly kit for reminder assembly
572368
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
No product available!
No product available!
XBee Pro Module - ZB Series 2 - 63mW with Wire Antenna, Digi International, RoHS
Retired
No product available!
Starter board LPCXpresso18S37 with LPC18S37 microcontroller (Cortex-M3). The set is equipped with a built-in programmer, buttons, diode, SPI Flash quad flash and USB - UART konwetrer
Retired
No product available!
No product available!
Computer fan housing Raspberry Pi 3, Raspberry Pi 2 model B and Raspberry Pi 1 model B + in dark red plastic color
Delivery date unknown
No product available!
POWER BANK 10,000 mAh with M-LIFE start-up cables (clamps)
Retired
No product available!
No product available!
Male terminal block, angled, 10-pin. Pitch 3.81mm. Height 7mm. 15EDGRC
Retired
No product available!
Module with black and white e-Paper display with a diagonal of 9.7 "and a resolution of 1200x825 px. Equipped with an HDMI interface. Waveshare 9.7inch HDMI e-Paper
Retired
No product available!
POWER SUPPLY FOR A ELECTRIC RAIL - DCC NIC - PRINTER PLATE AND PROGRAMMED LAYOUT
Retired
No product available!
No product available!
The Arduino 4 Relays Shield allows your Arduino driving high power loads that cannot be controlled directly by Arduino\'s digital pins. The Shield features four relays, each relay with 2 pole changeover contacts (NO and NC). Four LEDs indicate the on/off state of each relay. (A000110)
Retired
No product available!
Development kit containing the M24LR04E-R EEPROM chip. It consists of two ready-to-use boards that can communicate with each other via the I2C or RFID bus.
Retired
No product available!
No product available!
Mobile battery with a capacity of 10,000 mAh for charging portable electronic devices, powered by 5V. The Kruger & Matz power bank is charged via a USB port , in a set with several terminals . KM0138
Retired
No product available!
AVT kit for self-assembly of a miniature reminder. AVT5638 B