- Out-of-Stock
Li-Ion battery type 18650 with a nominal voltage of 3.6 V and a capacity of 3200 mAh. It is characterized by a discharge current of up to 4.8 A.
Attention!
The battery has no protection against overcharging and deep discharge. To charge the battery, use processor chargers with a charging cut-off at a voltage of 4.2 V.Data sheet
Manufacturer AKYGA EUROPE SPÓŁKA Z OGRANICZONĄ ODPOWIEDZIALNOŚCIĄ Wrocławska 1C 52-200 Suchy Dwór Poland contact@akyga.com
Responsible person AKYGA EUROPE SPÓŁKA Z OGRANICZONĄ ODPOWIEDZIALNOŚCIĄ Wrocławska 1C 52-200 Suchy Dwór Poland contact@akyga.com
Microprocessor charger with balancer (12 V DC supply), loads LiIon, LiPo, LiFe, Ni-Cd, Ni-MH, PB packs.
No product available!
Two-channel processor charger designed for Li-Ion cylindrical batteries in various sizes (including 18650). It can charge batteries both with PCM protection and without protection. The nominal charging current in the main phase is 0.5A per channel. XTAR MC2
4-in-1 module designed for 18650 Li-Ion batteries. It can be used as a 5 V voltage source, charger, UPS and battery protection module
No product available!
No product available!
Hotair soldering station 100..480 deg. C, soldering tip 75W 200..480 deg. C. Settings are displayed on LED displays
No product available!
Soldering station 5in1: hotair 100..480 degrees C, soldering tip 75W, power supply 0..15V / 1A, RF signal tester, voltage meter. Included, among others set of nozzles and wires for the power supply
No product available!
No product available!
No product available!
Laboratory power supply KORAD KA3005P 0-30V 5A communication with PC memory 5 power profiles
No product available!
This compact, inexpensive plastic gearmotor (high-power brushed DC motor with a 120:1 reduction gearbox) is well suited for use in small robots. While intended for operation at 4.5 V, it should run comfortably in the 3 V to 6 V range.
No product available!
Digital Proximity, Ambient Light, RGB and Gesture Sensor, Avago Technologies, RoHS
No product available!
Integrated analogue base station RFID (front-end) of the company EM Microelectronic with a frequency of 13.56MHz. The system has a SOP20 housing
No product available!
Computer fan housing Raspberry Pi 3, Raspberry Pi 2 model B and Raspberry Pi 1 model B + in dark blue plastic color
No product available!
Case for the Raspberry PI 2 model B, Raspberry PI 1 model B+ and Raspberry PI 3 computers, manufactured from high quality acrylic. CLEAR
No product available!
No product available!
No product available!
No product available!
Infrared sensor that allows measurement of distances up to 15cm, has a built-in infrared illuminator, IR receiver and a perimeter of the received signal
No product available!
Miniature (22x13.5x6mm) WiFi module b / g / n with TCP and UDP protocols operating in standalone and access point modes. 2.0mm goldpin connector. The module is equipped with a UART interface, it is also possible to control GPIO lines (also as PWM). Powered by 3.3V. Antenna: copper wire
No product available!
Li-Ion battery type 18650 with a nominal voltage of 3.6 V and a capacity of 3200 mAh. Akyga AKY0926