Products
Categories
- Main categories
-
- 3D PRINTING
- ACADEMIC OFFER
- ARDUINO
- AUTOMATION
- BOOKS
- DIY KITS
- AVT kits
- Audio
- Car
- Chargers
- Clocks, timers and schedule switches
- Communication
- Converters
- Development kits and modules
- Displays
- Electronic games
- Generators
- Hobbies and fun
- House
- Interfaces
- Light effects
- meters
- PC
- Power Supplies
- Pre-programmed circuits
- Printed circuit boards (PCB)
- Programmers
- Regulators, controllers
- Remote control
- Starter sets Ośla Łączka
- Starting sets for beginners
- Workshop tools
- Audio
- Other sets
- TOP-Q kits
- Totem
- UGears
- Velleman
- AVT kits
- EBOOKS
- ELECTRONICS
- Cables
- Cameras and accessories
- Communication
- Conductive materials
- Connectors
- ARK connectors (Terminal Block)
- Coaxial connectors (RF)
- Connectors
- Crocodile clip
- D-Sub drawer connectors
- DC power connectors
- FFC/FPC ZIF connectors
- Goldpin connectors
- IDC connectors
- JACK connectors
- JST connectors
- Jumpers
- Memory cards slots
- Other connectors
- Pogo pin
- RJ45 sockets
- Slip ring connector
- Supports
- Szybkozłącza
- USB connectors
- Cooling
- Displays
- Electronic modules
- A/D and D/A converters
- Audio
- Barcode readers
- CAN converters
- Converters USB - UART / RS232
- Data logger
- DDS/PLL generators
- Digital potentiometers
- Encoders
- Expanders of the I/O
- Fingerprint readers
- HMI modules
- Image and video
- JTAG accessories
- Keyboards, buttons
- LED drivers
- Memory card readers
- Memory modules
- Modules with power outputs
- Motor controllers
- Power modules
- RS485 converters
- RTC modules
- Servo Controllers
- TSOP infrared receivers
- USB Converters - I2C / 1-Wire / SPI
- Voltage converters
- Gadgets
- GPS
- Intelligent clothes
- LED - diodes, displays, stripes
- Luminous wires and accessories
- Memory cards and other data storages
- Passive elements
- PC accessories
- Printers
- Prototype boards
- Semiconductors
- A/C converters (ADC)
- Analog systems
- Audio systems
- Bridge rectifiers
- Button
- D/A Converters (DAC)
- DDS synthesizers
- Digital circuits
- Diodes
- Drivers of motors
- DSP microprocessors
- Energy counters
- Energy harvesting
- ESD security
- IGBT drivers and bridges
- Interface systems
- LED drivers
- Logic converters
- Memory
- Microcontrollers
- Optotriacs and optocouplers
- Other
- PLL generators
- Power systems
- Programmable systems
- Resetting systems
- RF systems
- RTC systems
- Sensors
- SoC systems
- Timery
- Touch sensors
- Transistors
- Sensors
- Accelerometers
- Air humidity sensors
- Air quality sensors
- Current sensors
- Distance sensors
- Flow sensors
- Gas sensors
- Gyroscopes
- Hall sensors
- Humidity sensors
- Infrared sensors
- Light and color sensors
- Liquid level sensors
- Magnetic sensors (compasses)
- Medical sensors
- Motion sensors
- PH sensors
- Position sensors
- Pressure sensors
- Pressure sensors
- Reflection sensors
- Sensors 6DOF/9DOF/10DOF
- Sensors of liquid quality
- Temperature sensors
- Vibration sensors
- Sound transducers
- Switches and buttons
- Cables
- INTERNET OF THINGS (IoT)
- MECHANICS
- POWER
- R/C MODELLING
- RASPBERRY PI
- Accessories for Raspberry Pi
- Audio video cables for Raspberry Pi
- Case Raspberry Pi
- Cooling for Raspberry Pi
- Displays for Raspberry Pi
- Extension modules for Raspberry Pi
- Memory cards for Raspberry Pi
- Power for Raspberry Pi
- Raspberry Pi 3 model A+
- Raspberry Pi 3 model B
- Raspberry Pi 3 model B+
- Raspberry Pi 4 model B
- Raspberry Pi 400
- Raspberry Pi 5
- Raspberry Pi cameras
- Raspberry Pi Compute Module
- Raspberry Pi model A/ B+/2
- Raspberry Pi Pico
- Raspberry Pi prototyping
- Raspberry Pi Zero
- Raspberry Pi Zero 2 W
- RETIRED PRODUCTS
- ROBOTICS
- SALE
- SOFTWARE
- STARTER KITS, PROGRAMMERS, MODULES
- Alchitry FPGA
- Altera FPGA
- Analog electronics
- Atmel SAM
- Atmel Xplain
- AVR
- Banana Pi
- BeagleBone
- chipKIT
- Coral
- CPLD Xilinx
- Cubieboard
- DFRobot FireBeetle
- Feather
- Freedom (Kinetis)
- FriendlyELEC
- HummingBoard
- Intelligent clothes
- Kit with a book
- LattePanda
- LPC (NXP)
- M5Stack
- Micro:bit
- Nvidia Jetson
- Odroid
- ODYSSEY
- Orange Pi
- Other development kits
- Peripheral modules
- PIC
- Raisonance
- Raspberry Pi RP2040
- RFID
- RISC-V
- SBC Embest
- SBC MYIR
- SBC others
- SBC UDOO
- Segger programmers
- SoMLabs
- Sparkfun MicroMod
- STM32
- STM32 Discovery
- STM32 MP1
- STM32 Nucleo boards
- STM8
- Teensy
- Universal programmers
- WRTNode
- Xilinx FPGAs
- WORKSHOP
- Adhesives and gluers
- Anti-static mats (ESD)
- Chemistry
- CNC milling machines
- Crimping tools
- Dispensing needles
- Drills
- Files
- Generators
- Handles, magnifiers
- Heat-shrink tubing
- Insulation strippers
- Keys
- Knives and scissors
- Laboratory power supplies
- Laminates
- Measuring devices
- Mikroskopy
- Mini drills and grindrers
- Organizers
- Oscilloscopes and accessories
- Pliers and pincers
- Power tools
- Riveting tools and rivets
- Screwdrivers
- SMD Accessories
- Soldering
- Tapes (aluminum, kapton, copper, insulating)
- Tweezers
- Ultrasonic cleaners
- Vices
- 3D PRINTING
New products
New products
zł2,361.88 tax excl.
ZYBO Z7-20 (Zynq Board) is a set with a programmable system from the Xilinx Zynq-7000 family - Z-7020. Digilent 410-351-20
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
ZYBO Z7 plate is a richly equipped tool containing a programmable system from the Xilinx Zynq-7000 family - Z-7020. The board is a modernized version of the Digilent ZYBO set released in 2012. The Z-7020 system is based on the Xilinx All Programmable System-on-Chip (AP SoC) architecture, which integrates the ARM Cortex-A9 dual-core processor and the Artix-7 programmable FPGA circuit. By adding the ZYBO multimedia equipment to it, we get a complete multitasking system, which includes: memory, audio and video inputs and outputs, USB interface, Ethernet interface, SD card slot . 5 connectors for Pmod modules can be used to expand the system.
The ZYBO kit is a cheaper alternative to ZedBoard sets .
ZYBO tiles are compatible with Vivado Design Suite and ISE / EDK. These tools allow you to develop software for the FPGA chip and ARM processor.
properties
- ZYNQ XC7Z020-1CLG400C FPGA system
- Dual-core Cortex-A9 667 Mhz processor
- DDR3 memory controller with 8 DMA channels
- Interface controllers: 1G Ethernet, USB 2.0, SDIO, SPI, UART, I2C, CAN
- Programmable (equivalent to Artix-7 FPGA)
- 1 GB x32 DDR3L, 1066 MHz RAM memory
- Quad-SPI Flash memory with a capacity of 16 MB
- Micro-SD socket
- 2 HDMI ports (Source and Sink)
- Pcam camera connector with MIPI CSI-2 support
- Ethernet interface (1 G / 100 M / 10 M)
- USB OTG 2.0 (host / device)
- Audio codec with headphone output and mic and line inputs
- Built-in JTAG programmer and UART-USB converter
- 6 buttons, 4 switches, 5 LEDs
- RGB LED
- 5 Pmod connectors
You might also like
ZedBoard is a low-cost development board for the Xilinx Zynq-7000 all programmable SoC (AP SoC). This board contains everything necessary to create a Linux®, Android®, Windows®, or other OS/RTOS based design. 410-248
ZYBO Z7 is the newest addition to the popular ZYBO line of ARM/FPGA SoC Platform; it surrounds the Zynq with a rich set of multimedia and connectivity peripherals to create a formidable single-board computer, even before considering the flexibility and power added by the FPGA. Digilent 410-351-10
No product available!
ZYBO Z7 is the newest addition to the popular ZYBO line of ARM/FPGA SoC Platform; it surrounds the Zynq with a rich set of multimedia and connectivity peripherals to create a formidable single-board computer, even before considering the flexibility and power added by the FPGA. Zybo Z7-10 with SDSoC Voucher. Digilent 471-014
No product available!
ZYBO Z7 is the newest addition to the popular ZYBO line of ARM/FPGA SoC Platform; it surrounds the Zynq with a rich set of multimedia and connectivity peripherals to create a formidable single-board computer, even before considering the flexibility and power added by the FPGA. Zybo Z7-20 with SDSoC Voucher. Digilent 410-015
No product available!
The fan designed for use with the Digilent ZYBO Z7-20 plate mounted on the heat sink allows better air flow, which results in lowering the FPGA temperature. The fan has a 3-pin connector, the supply voltage is 5 V. In addition to the fan, there are screws for fixing. Digilent 240-130
No product available!
Other products in the same category (16)
Ethernet module dedicated to Coral Dev Board Micro. It supports power over Ethernet (PoE) technology and connects to the base board via B2B connectors. Coral G650-07975-01
The MPX5700AP air pressure sensor with a measuring range from 15 to 700 kPa. It communicates via the I2C interface. DFRobot SEN0456
No product available!
Board with RP2040 microcontroller and W5100S network chip. The module is equipped with an Ethernet connector. WIZnet W5100S-EVB-Pico
No product available!
KAmodLIS35DE is a module with a three-axis LIS35DE accelerator from STMicroelectronics. The chip has a digital signal output (I2C or SPI bus) and allows acceleration measurement in three axes.
Grove module with FSR402 pressure sensor. The board is equipped with a Grove connector with an analog output. Seeed Studio 101020553
Riverdi RVT70HSMNWC00 TFT LCD display module with 7" diagonal and 1024x600 pixel resolution equipped with capacitive touch panel, DC/DC converter and protective glass. It communicates via a MIPI-DSI interface. SoMLabs SL-TFT7-TP-600-1024-MIPI v.1.1
Module with a buzzer (without generator) controlled by a digital interface. It allows you to generate simple sounds by changing the frequency of the control signal. DFRobot DFR0032
Transparent case designed for micro:bit educational modules. Compatible with LEGO. DFRobot FIT0533
The STM32F469 Discovery kit (32F469IDISCOVERY) allows users to easily develop applications with the STM32F469 high-performance MCUs with ARM®Cortex®-M4 core and Chrom-ART Accelerator™.
DFRobot Gravity analog light intensity module for Arduino and Raspberry Pi. DFRobot DFR0026
ZYBO Z7-10 (Zynq Board) is a set with a programmable system from the Xilinx Zynq-7000 - Z-7010 family. Educational offer. Digilent 410-351-10
No product available!
Module with I2C driver based on the HT16K33 system. It is equipped with STEMMA QT connectors and is dedicated to 8x8 LED matrix displays with a diagonal of 1.2". Adafruit 1048
The low-power consumption micro-controller intentionally designed for Internet of Things (IoT) projects. The board integrates a Dual-Core ESP-WROOM-32 module, which supports MCU and Wi-Fi &Bluetooth dual-mode communication. DFR0478
Love To Code Chibi Chip is an educational module for learning programming designed for beginners of all ages and levels who want to start learning programming without installing software. DEV-14591, Adafruit 3674
A small single board computer designed for the development of artificial intelligence and the Internet of Things (IoT). It integrates an ARM Cortex-A78 core CPU and an NVIDIA Ampere GPU, as well as 4GB of RAM. Nvidia 900-13767-0040-000
No product available!
Module with 3-axis accelerometer ADXL343 and precise temperature sensor ADT7410 dedicated to Feather series boards. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4147