Category: STARTER KITS, PROGRAMMERS, MODULES

Module with 4 Qwiic connectors for Teensy boards. Communication via the I2C interface. SparkFun DEV-17119

Flash Programmer for ARM and Cortex cores, Segger

The IO expansion module is designed to work with the micro:bit educational board. There are 20 GPIO pins on the board, a buzzer and a voltage stabilization circuit

Knit conductive 100% silver fabric with resistance of less than 1 ohm per foot in any direction across the textile. Great for use with FLORA. 20 cm x 20 cm piece. Adafruit 1167

This is the second version of the Flora NeoPixels, which runs at at \'high speed\' 800KHz communication. Adafruit 1260

ATOM Lite development kit complete with programmable AC/DC HUB switch module. M5Stack ATOM SWITCH

ATOM Lite development kit complete with DRV8825 stepper motor driver module. M5Stack ATOM STEPMOTOR

USB module based on MAX3421E wrap designed for M5Stack sets. It communicates with the evaluation kit via the SPI interface and allows the addition of a Host or USB device function. M5Stack M020

Lipo battery with a capacity of 750 mAh for the M5Stack sets. Modules can be connected in parallel and stacked. M5Stack M002

Prototype kit for use in industry. It includes a prototype board with an M-BUS connector, TTL-RS485 converter, connectors and a DIN rail. M5Stack Base26

Module with gas sensor SGP30. It allows you to measure the content of total volatile organic compounds (TVOC), carbon dioxide equivalent (eCO2), ethanol and H2 in the air. M5Stack U088

Module with a transmitter designed for communication via a laser beam transmitted in the air. M5Stack Laser.Tx Unit

Compact module with vibration motor. It consists of a DC motor and an eccentric wheel. M5Stack Vibration Motor Unit

Module with LCD display 16x2 characters with gray backlight. It is supplied with the voltage from 3.3 V to 5 V and communicates via the I2C interface. DFRobot DFR0557

Module with 6-axis BMI160 motion sensor (accelerometer and gyroscope) with 16-bit data resolution. It is supplied with the voltage in the range from 3.2 to 6 V. I2C communication. DFRobot SEN0250

6-port I2C port expander for M5Stack sets. It allows you to connect several devices with the same address to one I2C bus. M5Stack U040-B

Module with 16-channel PCA9685 servo driver designed for Raspberry Pi minicomputers. The board is equipped with a USB Type C power connector. SparkFun DEV-15316

Module with 4-channel ADC ADS1015 converter. The system enables analog voltage conversion for both single signals (11-bit resolution) and differential signals (12-bit resolution). I2C communication. SparkFun DEV-15334

Power module with a USB Type-C connector based on the STUSB4500 system. It enables powering devices with voltages ranging from 5 V to 20 V and currents up to 5 A. Configuration via the I2C interface. SparkFun DEV-15801

Real time clock (RTC) module. It allows you to read data about the date and time. Communication with the module takes place via the I2C interface. SparkFun BOB-16281