Category: STARTER KITS, PROGRAMMERS, MODULES

A module with a rotary encoder and RGB LED lighting for M5Stack sets. It communicates via the I2C interface. M5Stack U135

A module with a set of environmental sensors (pressure, temperature and humidity sensor, light sensor, MEMS microphone) designed for micro:bit. Pimoroni PIM355

Vertical Grove socket for through-hole mounting, 4-pin, pitch 2.0 mm. Set of 10 pieces. Seeed Studio 110990030

Module with light sensor - LS06-S phototransistor. The board is equipped with a Grove connector and has an analog output. Seeed Studio 101020132

A module with a 24-bit ADC converter HX711, which enables reading data from strain gauges and scales. The board is equipped with a Grove connector and communicates via a serial interface. Seeed Studio 101020712

Module with OTP-538U non-contact temperature sensor. The board is equipped with a Grove connector and has analog outputs. Seeed Studio 101020062

Module with LED driver. It can control LED strips with a length of 1 to 2 meters at a voltage of 9 V or from 1 to 5 meters at a voltage of 12 V. Seeed Studio 105020002

Module with liquid turbidity sensor. The board is equipped with a Grove connector and communicates via a digital or analog interface. Seeed Studio 101020752

ToF VL53L0X distance sensor module designed for M5Stack sets. It allows you to measure distances up to 2 m and communicates via the I2C interface. M5Stack U072

A module with an acceleration and rotational speed sensor based on the LSM6DSOX system and the LIS3MDL magnetometer. Equipped with a STEMMA QT connector, it communicates via the I2C, SPI or I3C interface. Adafruit 4517

Adapter dedicated to the Nintendo Wii Nunchuck. It allows you to connect the controller to the development board via the I2C interface. Adafruit 4836

Module with a logarithmic digital potentiometer based on the DS1841 chip. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4570

Module with WiFi Espressif ESP32-S2. It integrates two regulators, SPI Flash memory, LiPo charging circuit and RGB diode. It is equipped with a STEMMA QT connector. Adafruit 4775

Module with waterproof barometer LPS33HW. It enables pressure measurement in the range from 260 to 1260 hPa and communicates via I2C or SPI. Adafruit 4414

Transparent case made of tinted plastic, designed for micro:bit educational modules. Adafruit 4852

The board is equipped with ATSAME51 microcontroller (ARM Cortex-M core) with CAN bus and SPI Flash memory, GPIO pins and a connector for connecting the battery with the charging circuit. Adafruit 4759

Module with WiFi Espressif ESP32-S2 WROOM. It integrates a set of peripheral devices - capacitive touch sensors, SPI, UART, I2S and I2C. SparkFun WRL-15663

Module with a 433 MHz radio receiver for M5Stack sets. Based on the SYN531R chip, it has a built-in PCB antenna. M5Stack U113

A module with a 433 MHz radio transmitter for the M5Stack sets. Based on the SYN115 chip, it has a built-in PCB antenna. M5Stack U114

Bluetooth 5.2 communication kit. It uses the STM32WB15CC microcontroller (320 kB Flash, 48 KB SRAM, ARM® Cortex®-M4 and Cortex®-M0+). STMicroelectronics NUCLEO-WB15CC