Adafruit 1126 - Sewable Snaps - 5mm Diameter - Card of 24

Adafruit 1059 - Flora Wearable Ultimate GPS Module

5 mW red laser diode module displaying a point. It uses the PWM signal for control. It can be supplied with the voltage from 4.8 V to 5.2 V. Adafruit 1056

Module with 5V relay and timer. It allows the implementation of delayed switching on or off of the circuit with adjustable time in the range from 1 s to 100 s and from 1 s to 15 min.

Step-Down converter with input voltage up to 36 V which effectively reduces it to 3.3 V, while maintaining current up to 500 mA. Pololu 2842

8x8 matrix or a 4-digit 7-segment display. Matrices like these are \'multiplexed\' - so to control all the seven-segment LEDs you need 14 pins. Adafruit 1002

A small tripod with 1/4" mounting screw designed for Raspberry Pi HQ Camera. Pocket-sized and very lightweight, withstands loads up to 1kg. ArduCAM UB0216

Stereo Power Amplifier

4 channel 4.8 KHz 24 bit A/D converter

WRL-13019

Module with an infrared sensor AMG8833 - a measurement matrix with a resolution of 64 pixels (8x8). It offers an accuracy of 2.5°C and the ability to detect people at a distance of up to 7 m. Communication with the sensor is via the I2C interface. SparkFun SEN-14607

HAT with two-channel DC motor driver for Raspberry Pi. It has an operating voltage from 6 to 24 V and a continuous current of up to 10 A. It can be controlled by a PWM signal or by means of built-in buttons. Cytron HAT-MDD10

WRL-12991

Module with a stepper motor driver based on the DRV8825 system. allows the bipolar motor to be supplied with current up to 1.5 A per phase, without the use of a heat sink. The system can be supplied with voltage up to 45 V. Pololu 2987

DRV8825 Stepper Motor Driver Carrier with male header pins installed, so no soldering is required to use it with an appropriate 16-pin socket or solderless breadboard. Pololu 2982

Adafruit 1203 - Barcode Reader/Scanner Module - CCD Camera - USB Interface

This module enables the Feather series range to be expanded with 8 12-bit PWM outputs that can be used, for example, to control servos or LED diodes. Adafruit 2928

This synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 5 V with an available output current of around 9 A.