DHT21 - temperature and humidity sensor

Module with temperature and humidity sensor DHT11. It allows you to measure humidity in the range of 20 ... 90% and temperature (0 ... 50 ° C). DFRobot DFR0067

Module with SHT30 temperature and humidity sensor designed for Wemos D1 Mini

Analogue temperature and humidity sensor module based on SHT30 sensor. It is characterized by high reliability and stability with low energy consumption. It is compatible with 3.3V and 5V controllers, such as Arduino, micro:bit, ESP32. DFRobot DFR0588

Module with a digital temperature and humidity sensor based on the SHT31. Communication via the I2C interface. DFRobot SEN0331

High-end temperature and humidity sensor module, offering ±1.0% RH and ±0.1°C precision and full I2C communication. With 3.3 to 5V voltage compatibility, STEMMA QT connectors and IP67 protection, it is easy to integrate and resistant to harsh environmental conditions. Ideal for IoT projects, weather stations and automation systems requiring accurate measurements. Adafruit 6174

A module with a temperature and humidity sensor based on the AHT20 system. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4566

Temperature and humidity sensor module based on the HTS221 chip. Equipped with a STEMMA QT connector, it communicates via an I2C or SPI interface. Adafruit 4535

Module with BME680 sensor for measuring the concentration of volatile organic compounds (VOC), pressure, temperature and humidity. I2C or SPI communication. DFRobot SEN0375

Temperature and humidity sensor module with DHT22 sensor (AM2302)

 relative humidity sensor with integrated temperature sensor for highly accurate measurements at low power. With the TI HDC1080, you can determine the relative humidity of the environment with up to 14 bits of resolution. Digilent 410-347

Module with a BME680 sensor that allows you to measure temperature, humidity, pressure and gas detection. The board is equipped with a Grove connector and communicates via I2C and SPI. Seeed Studio 101020513

Air humidity and temperature sensor with 1-Wire interface.

Module with a temperature and humidity sensor based on the SHT40 system. It communicates via the I2C interface. SEN0428

Module with a temperature and humidity sensor based on the SHT31-D system. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 2857

Digital temperature and humidity sensor with calibrated digital output signal. Equipped with a 2.5 mm 4-pin male stereo audio connector that works perfectly with the Sonoff TH10/TH16 socket. Sonoff Si7021

Grove module with temperature, humidity and pressure sensor. The board is equipped with a Grove connector and communicates via I2C or SPI. Seeed Studio 101020193