Best sellers
There are 16475 products.
Linklt Smart 7688 is an IoT module with WiFi interface based on the MediaTek MT7688 system operating under the control of the distribution of the Linux operating system derived from OpenWrt. LinkIt Smart 7688 is a great base for creating complex IoT projects or a smart home. Seeed Studio 102110018
Miniature DC motor with a rated voltage of 3 V. It can rotate up to 11,800 rpm and consumes a current of up to 335 mA
ToF laser rangefinder. It enables detection of many objects, has a field of view of about 25° and is able to detect objects at a distance of up to 3 m. Communicating via the I2C interface. SparkFun SPX-17072
Adafruit VL53L0X Time of Flight Distance Sensor is a laser distance sensor using the ToF (Time of Flight) measurement technique. The module is powered by 2.8 ... 5V voltage and can measure up to 1000mm. Adafruit 3317
This module features a fixed-gain, 38 kHz modulated IR sensor and a corresponding IR LED with oscillator circuit to make a tiny proximity sensor. This low-brightness version draws an average of 8 mA at 5 V and has a typical sensing range up to approximately 12 inches (30 cm).
Gravity: 360 Degree Hall Angle Sensor is a rotation angle sensor measuring a value in the range of 0-360 ° with an analogue output, powered by 5V. DFRobot SEN0221
Module with the ATECC608A cryptographic chip. It allows you to add strong security to an IoT node, edge device, or embedded system. SparkFun DEV-18077
Module with LCD IPS touch display with a diagonal of 2.8" and a resolution of 320x240 px. Communication via the SPI interface. Waveshare Pico-ResTouch-LCD-2.8
An expansion board that enables the implementation of TCPP01-M12 functions and USB Type C surge protection for VBUS and CC lines suitable for sink applications. STMicroelectronics X-NUCLEO-SNK1M1
A mini water pump with a capacity of 240 l/h designed for home automatic irrigation systems. It is immersed in water, powered by 12 V and has a power of approx. 5 W
Li-Po battery with a rated voltage of 3.7 V and a capacity of 450 mAh, equipped with a PCM protection and a 2.5 JST-RCY connector. Akyga LP502248
Module with barcode and QR scanner. It allows you to read one-dimensional and two-dimensional codes using the intelligent image recognition algorithm. It has a built-in USB and UART interface. SparkFun SEN-18088
A small WiFi module designed for IoT applications. It can communicate with the motherboard via the I2C or UART interface. DFRobot TEL126
The IO expansion module is designed to work with the micro: bit educational board. There are 19 IO pins on the board, a buzzer and a voltage stabilization circuit are placed. DFRobot MBT0008
The UM7 orientation sensor from Redshift Labs is an Attitude and Heading Reference System (AHRS) that contains a three-axis accelerometer, rate gyro, and magnetometer. It combines this data using an Extended Kalman Filter to produce attitude and heading estimates.
Switching power supply from MEAN WELL with 50W, 5V DC output voltage and 10A output current. Mounting on a DIN rail. Built-in overload and short-circuit protection. MDR-60-5
The board features a Zynq XC7Z020, Ethernet, HDMI in/out, MIC in, Audio out, Arduino Interface, 2 Pmods, 16 pin GPIO header, user LEDs, pushbuttons and Switches. 6003-410-0
The UM7-LT orientation sensor from Redshift Labs is an Attitude and Heading Reference System (AHRS) that contains a three-axis accelerometer, rate gyro, and magnetometer. It combines this data using an Extended Kalman Filter to produce attitude and heading estimates. This LT version of the UM7 does not have an enclosure.
Extension module with a set of environmental sensors and an LCD display for Raspberry Pi minicomputers. Pimoroni PIM458