Best sellers

Piergiacomi CSP 30/2 is a wire stripper for medium and large diameter wires, intended for workshop and service use. Not suitable for work in ESD zones.

ToF distance sensor (Time of flight) with a range of up to 5 m. The module is supplied with the voltage of 3.3 V and communicates via the I2C interface. SparkFun SEN-19037

Pololu Universal Aluminum Mounting Hub for 3mm Shaft, M3 Holes (2-Pack)

Aluminum bracket with holes for M3 screws for 37D mm gear motors. Pololu 1995

Module with WiFi Espressif ESP32-S2. It integrates a LiPo charging circuit and an RGB diode. It is equipped with a STEMMA QT connector. Adafruit 5000

Module with the driver of the resistive touch panel. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 5423

4-in-1 module designed for 18650 Li-Ion batteries. It can be used as a 5 V voltage source, charger, UPS and battery protection module

Fiberlogy Matte PET-G Green is a 3D filament with a diameter of 1.75 mm and a weight of 0.85 kg, offering a matte finish, high strength, and chemical resistance. Suitable for printing functional and decorative elements, it ensures durability and an aesthetic appearance of prints.

4-digit 7-segment 0.56 "LED display. Built-in HT16K33 controller allowing communication via I2C bus. Equipped with STEMMA QT connector. Adafruit 5599

Module with 3.5 mm TRS connector for MyoWare 2.0 muscle tension sensors. It allows you to conveniently connect the sensors with the development board via the Arduino shield. SparkFun DEV-18386

ToF distance sensor (Time of flight) with a range of up to 5 m. The module is supplied with the voltage of 3.3 V and communicates via the I2C interface. SparkFun SEN-19218

MicroMod main module with Alorium Sno M2 chip. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SparkFun DEV-18030

A4990 Dual Motor Driver Carrier

The module with 2 relays is designed for the M5Stack sets. It allows you to control devices with an operating voltage of up to 250 V AC and a current of up to 8 A or a voltage of 28 V DC and a current of 8 A. M5Stack U131

Blue LED strip with SMD 5050 diodes. It is powered by 12 V DC, has a length of 5 m and 60 LEDs/m. Protection level IP21

Power supply dedicated to the Build HAT module for the Raspberry Pi. It has an output voltage of 8 V and a DC 5.5 x 2.1 mm connector. Raspberry Pi SC0748

The Step-Down D24V6F5 Buck Voltage Regulator module gives the output voltage of 5V with a wide input voltage range of 7-42V and a maximum output current of 600 mA. Pololu 2107

A robotic gripper based on the SG92R servo. It has an opening and closing angle of 90° and mounting holes compatible with Lego. M5Stack U102

Pololu 4-Channel RC Servo Multiplexer (Assembled)

A set with an analog audio level indicator in the form of a panel meter. Powered with AC or DC voltage from 6 to 12 V. It consists of two VU meters, module and wires