Best sellers

DAGU gearmotors; 4.5V with a no load current of 190mA while possessing a gearbox ratio of 48:1 and a wheel speed of 140 RPM unloaded. axis. ROB-13302

Plastic enclosure Z58 lightgray PS

Z59JpH TM ABS - Hermetic enclosure Z59 lightgray, transparent lid with gasket & brass bushing ABS

Module with pressure, humidity and temperature sensor. It uses the I2C interface and allows the connection of additional wind sensors via the RJ11 connector. SparkFun DEV-13674

GY-346 is a module with a digital acceleration sensor (accelerometer) ADXL346; communication on the I2C / SPI bus

The module with an 8x8 LED matrix designed for Wemos D1 Mini

UPS uninterruptible power supply module for Raspberry Pi, allowing the microcomputer to continue working and shut down safely after a power failure. Uninterruptible power supply included. SB Components UPS HAT

Expansion board with LoRa E22-900T22S module for Raspberry Pi. It supports the LoRaWAN protocol and allows communication in the 868 MHz frequency band. SB Components 22571

Connector for connecting a 50-pin ribbon with a 0.5 mm pitch to a printed circuit board. Riverdi ZIF0550UH

A universal programmer compatible with safety test cables from the O.MG Cable, O.MG Plug, O.MG Adapter and O.MG UnBlocker series. O.MG Cable: USB A+C Programmer

Hermetic casing ZP90.60.40 light bottom with ears - colorless top with a flooded gasket and brass PC sleeves

Pololu - 1502

Plastic enclosure Z95 lightgray PS

GY-9250 is a 9 Degrees of Freedom (9DoF) module with the InvenSense MPU-9250 chip. It has a built-in gyroscope, accelerometer and magnetometer.

Hermetic enclosure Z90 lightgray with gasket PS

This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 9 V. The board measures only 0.7″ × 0.7″, but it allows a typical continuous output current of up to 2.5 A. Typical efficiencies of 85% to 95% make this regulator well suited for powering moderate loads like sensors or small motors.

Accelerometer and gyroscope module, allows measurement of acceleration in the range of +/- 16 G and angular velocity in the range up to +/- 2000 dps. modMPU6500 (GY-6500)

modTSL2561 is a module containing a light sensor TSL2561; communication with the system takes place using the I2C bus

Plastic enclosure Z81 ABS

The module allows measuring the light around the sensor. The measuring range is in the range 1 - 65535 LUX, and communication takes place using the I2C bus. modBH1750 (GY-302)